How to Replace the Top Cover On a Gateway 600 Laptop

Use a flat head screwdriver when replacing a laptop bezel.

The top cover of a Gateway 600 notebook computer is located directly above the keyboard. Gateway refers to this cover as the "keyboard cover" or the "keyboard bezel." If this cover becomes damaged, it can be removed and a replacement can be installed in its place. There are two notebook models in the 600 series, but the process for replacing the top cover is the same for both.

Things You'll Need

• Flat head screwdriver

Instructions

1. Turn the computer off. Disconnect the power cable.

2. Turn the computer over and remove the battery by sliding the release latch in the "open" direction indicated. Lift the battery out and up.

3. Turn the computer over so it is face up. Open the notebook.

4. Insert the tip of a flat head screwdriver into the bottom of the keyboard cover directly above the "SysRq" key on the keyboard. With the screwdriver in place, gently twist it back and forth to pry the cover off.

5. Slide the left end of the replacement keyboard cover into place. Press the right side of the cover straight down into place.

6. Press down on the middle of the keyboard cover and on the right end. Each area will click into place.

Tips & Warnings

• Make sure the replacement cover lies flat on the notebook before attempting to snap it into place.

References

• Gateway User Guides: 600 Series Notebooks