How to Cover Old Brick With Vinyl Siding

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Tape measure

  • Level

  • Chalk line

  • 1 inch by 3 inch furring strips

  • Circular saw

  • Drill

  • Assorted bits

  • Concrete screws

  • Corrosion-resistant nails

  • Tin snips

  • Utility knife

  • Snap lock tool

Old brickwork can be covered with vinyl siding.

Over time the brickwork on your house may start to look worn and faded. Installing vinyl siding over existing brick is an easy and economical way to update the look and feel of your house. Vinyl siding is composed of a series of channels and panels that interlock with one another to form a cohesive, weather-resistant shell over the exterior of your house. Furring strips should be mounted to the brick, and then the vinyl channels are affixed to the wooden furring strips. The siding panels are fitted into the channels and fastened to the furring strips.

Advertisement

Affixing Furring Strips to Brick Siding

Step 1

Snap base guide lines around the bottom of the house. Consult the vinyl siding manufacturer's instructions regarding the distance from the ground that the vinyl siding should begin.

Advertisement

Video of the Day

Step 2

Affix furring strips horizontally around the base of the house. Follow your chalk guide lines. Fasten the furring strips by using a drill affixed with a masonry bit. Drill through the furring strips and into the bricks behind them; use concrete screws to hold the furring strips in place. Cut furring strips to the appropriate length using a circular saw.

Advertisement

Step 3

Attach furring strips vertically along the sides of the house. Position the furring strips 18 to 24 inches apart.

Step 4

Install furring strips along the eaves of the house.

Installing Vinyl Siding

Step 1

Attach the starter strip along the base of the house. Use corrosion-resistant nails to fasten the aluminum starter strips to the furring strips. Take care not to over-drive the nails and warp the starter strip.

Advertisement

Step 2

Install J-channel to the corners of the house, and around windows and doors. Use tin snips to cut the vinyl J-channel pieces to length. Leave 1/4 inch of space between vinyl pieces to allow for expansion in hot weather. Fasten the J-channel with corrosion resistant nails positioned in the center of the prefabricated nail slots. Leave between 1/32 and 1/16 inch of the nail shaft exposed to allow the vinyl to move in high heat.

Advertisement

Step 3

Install utility trim to the underside of windows and along horizontal eaves. Attach J-channel to sloped eaves.

Step 4

Install the vinyl siding panels starting from the base and work up. Fit the first row of panels into the starter strip, and position the ends in the J-channel, leaving 1/4 inch of space between the end of the panel and the back of the channel. Where two panels meet, overlap them by 4 inches. Use corrosion resistant nails to attach the vinyl siding panels to the wooden furring strips.

Advertisement

Step 5

Check the level every 3 or 4 siding courses. If you find that the level is getting off track, make minor adjustments over several courses, as opposed to making a single, dramatic repair.

Step 6

Cut the panels to fit around windows and doors. Use tin snips to cut the width of the panels, and a utility knife to slice them lengthwise.

Advertisement

Step 7

Punch lugs in the edge of panels fitting underneath windows and into utility trim run along horizontal eaves. Use the snap lock tool to punch lugs every 16 inches. Lock the panels into place by punching the edge with punched lugs up into the utility trim.

Step 8

Cut panels to fit into J-channel run along sloped eaves. Use tin snips and your utility knife to cut the panels to the write length and angles.

Advertisement

Video of the Day

references

Report an Issue

screenshot of the current page

Screenshot loading...