There are times when the polarity of your phone line matters, even today. Simply put, reverse polarity means that the two wires that carry your dial tone are improperly connected at the phone jack. Though most phones can work regardless of this, reverse polarity can affect the proper functioning of equipment such as satellite television receivers and alarm systems. Fixing reverse polarity isn't something you have to pay the telephone company to fix for you.
Things You'll Need
Remove the screws from the faceplate of the phone jack with the screwdriver.
Ease the jack away from the wall. You don't want to inadvertently pull out any wires before you see where they are connected.
Observe the back of the jack. Most jacks will have four colored wires: green, red, yellow and black. The incoming telephone cable that carries your dial tone and connects to the phone jack should be connected to the green and red terminals.
Loosen the screws that fasten the telephone wires to the back of the phone jack.
Switch the two wires around. Wrap the exposed copper end of the wire that was attached to green terminal to the red, and vice versa.
Tighten the screws slowly. Inspect to make sure the wire stays in contact with the screw as you tighten it.
Replace the jack and screw it back into the wall.
Verify your connection by plugging in a known, working telephone and checking for dial tone.
Tips & Warnings
- Be sure to grab one wire at a time. Telephone lines are low-voltage lines, so they won't seriously injure you. If you do happen to be holding onto both wires when someone tries to call you, you will get an unpleasant jolt.
- Photo Credit testeur de cable image by serge simo from Fotolia.com
How to Check for Reverse Polarity
Reverse polarity occurs when the wires of a building's electrical system are connected to the wrong terminals of an outlet. If the...
How to Fix Reverse Polarity Receptacles
How to Fix Reverse Polarity Receptacles. OK, so you just purchased your new home and you think everything is great, when all...
How to Use a Diode for Reverse Voltage Protection
Reverse voltage protection is a prerequisite for good electrical/electronic design techniques. All high-quality electronics come with this feature, but many low-end electronics...