In 1978, Bill Biesemeyer developed a T-square style table saw fence that is still the industry standard to this day. Biesemeyer's fence design allows for the fence to be set accurately to 1/64 inch, and stays square to the blade no matter the position on the fence. A Biesemeyer fence can be installed on nearly any hybrid or cabinet table saw.
Things You'll Need
- Square tube front rail
- L-shaped back rail
- Dual-sided fence
- Locking mechanism
- Mounting bolts & nuts
- Allen wrench
Attach the square tube front rail to the front edge of the saw table using bolts and nuts. The narrow edge of the tube should be against the saw table, and the rail should be positioned evenly about 1/2 inch down from the top of the table.
Install the back rail against the far edge of the saw table using bolts and nuts. The protruding portion of the L-shape should be on the bottom, pointing away from the saw.
Position the fence with the fence's locking mechanism on the front rail, with the fence sitting on the saw table.
Adjust the height of the front and rear rails so that the fence glides evenly just above the surface of the table.
Move the fence so that the front edge is even with one of the miter slots and lock the fence in place. Using an Allen wrench, adjust the screws on either side of the lock to alter the angle of the fence until the edge of the fence matches the miter slot perfectly.
Unlock the fence, and slide it to the other miter slot. Check to see that the the fence is perfectly parallel to the slot.
Move the fence to the right of the blade. Raise the blade and make a test cut. The board should remain firmly against the fence and the blade should not bind. If there is any binding, recheck the fence for square.
How to Install Fence Posts in Concrete
Installing the fence posts is a crucial first step to getting your new fence up and ready to go. Use a good...