Swimming Pool Heater Instructions

Swimming Pool Heater Instructions thumbnail
Maintain warm swimming water by adding a pool heater.

Swimming pool heaters are a great addition to your pool. The heater has the task of heating the pool water to a specific temperature before the water is returned to the pool. The pool heater is installed outside of the pool, between the pool and the pool filter. Adding a pool heater to your pool's plumbing system only takes a few steps and will provide you with inviting and warm water for swimming. Does this Spark an idea?

Things You'll Need

  • Pool heater
  • pH test kit
  • Leveling tool
  • Paving stones
  • PVC piping
  • Small saw or cutting blade
  • PVC compound
Show More

Instructions

    • 1

      Use a pH test kit to test the current swimming water; add any necessary chemicals in order to balance the water. It's imperative that the swimming pool water is pH balanced before installing a pool heater.

    • 2

      Disconnect power to the pool pump by unplugging the electrical outlet or turning off the circuit breaker. Clean the pool filter and skimmer of all large debris to prevent clogging the pool heater.

    • 3

      Locate a level spot for the pool heater, about two to three feet away from the pool filter. If needed, use paving stones and a leveling tool to create a level area.

    • 4

      Use PVC pipe and attach the pool filter return valve to the inlet valve on the pool heater. The valves are labeled but if needed, the owner's manual will have a diagram. Cut the PVC pipe to fit the area using a small saw or cutting blade. Attach another piece of PVC piping to connect the return jet valve located on the sidewall of the pool to the outlet valve on the pool heater.

    • 5

      Set the thermostat located on the pool heater to the desired temperature. Restore power to the pool pump by plugging the electrical cord in or turning the circuit breaker back on. Allow the water to cycle through the pool filter and pool heater, back into the pool.

    • 6

      Check for any leaks on the PVC piping, while the water is flowing. If any leaks are noticed, turn the system off and apply PVC joint compound to seal the leaky areas.

Related Searches:

References

  • Photo Credit A swimming-belt in a swimming-pool. image by Saskia Massink from Fotolia.com

Comments

You May Also Like

  • How to Install a Hayward Pool Heater

    Hayward Pool Products offers a wide range of residential swimming pool products including swimming pool heaters. A swimming pool heater heats the...

  • Pool Solar Heater Installation Instructions

    In most colder areas, outdoor pools can be open only from Memorial Day to Labor Day because the water is simply too...

  • Pool Heater Installation

    Swimming pool heaters typically run on natural gas or propane. Solar and heat-pump heaters are gaining popularity. No matter what type of...

  • DIY Swimming Pool Heater

    Swimming pool heaters are a wonderful addition to your swimming pool's plumbing system. The heater sits between the pool filter and pool...

  • How to Turn on a Hayward Pool Heater

    Hayward pool heaters are devices that control the temperature of pool and spa water. The heaters are used to warm the water...

  • How to Install a Jacuzzi Pool Filter

    Install a Jacuzzi cartridge pool filter for easy maintenance and sparkling clear pool water. The filtration process operates on water pressure. The...

  • How to Add a Heater to a Pool

    Swimming pool water heaters give you maximum time in your swimming pool, by heating the water and reducing the risk of getting...

Related Ads

Featured