Tar paper, also known as felt paper, is an asphalt paper that protects the openings around windows and doors during construction. Tar paper also can help improve drainage around these openings. The paper prevents water from passing through the openings into the home while allowing a small level of moisture. In addition to water protection, tar paper also helps to seal the openings, preventing heat from escaping the home and cold air from seeping in from the outside. To be effective, however, you must trim the paper carefully, placing it precisely around the openings and installing the pieces in the proper order.
Things You'll Need
- Measuring tape
- Tar paper
- Utility knife
- Hammer stapler
Measure the sides of the openings for length of the tar paper being applied. Add 4 inches to the measurements so that applied paper will overlap.
Measure the width of the opening from the outside to the inside. Add 4 inches to the measurement to get the width of the pieces of building paper.
Cut the tar paper to the lengths and widths taken. To cover a single opening will require four strips of tar paper: two for the sides; one for both the top and bottom of the opening.
Attach the bottom strip to the opening. The strip should be placed so that it lies 2 inches beneath the bottom of the opening and extends 2 inches to each side of the opening. Use the hammer stapler to secure the strip to the building. Fold the strip over the opening, using a utility knife to cut notches at the fold to allow the strip of paper to fold cleanly over the edges. The strip should fold over and have 2 inches on the other side of the opening to attach using the stapler. Staple the two flaps created inside the opening when the strip was notched in order to fold it over to the wall of the opening.
Attach the two side strips using the same process as the bottom strip. The ends of the two strips should overlap the bottom strip to create a drainage plane for water running down the length of the building.
Attach the top strip, notching it as you did the bottom strip. Overlap the side strips to complete the drainage plane. The final construction should create a complete square around the window or door opening.
Tips & Warnings
- Use more staples in windier areas when attaching the tar paper to provide a more secure coverage.
- Photo Credit Ablestock.com/AbleStock.com/Getty Images
Tar Paper Vs. Tyvek
When it comes to using protective barriers in construction work, some believe it is a matter of Tyvek versus tar paper. Those...
How to Wallpaper Around Windows
Whether you are installing wallpaper on all four walls in a room or just on one wall chances are you will have...
How to Install Caulking Around Windows
Stop those annoying little drafts in your home by caulking around the exterior of your windows. Use a paintable caulk so that...
How to Remove Black Tar Paper Under Tiles
Tar paper serves as an adhesive on flooring and was most commonly used in homes built through the 1970s. Its purpose is...
How to Install Roofing Tar Paper
Water is an enemy to your home. Rain, snow, hail and sleet pound your roof year after year, getting in between the...
How to Use Tar Paper Under Siding
Before installing siding to the structure of a home, it is important to fasten some type of water-resistant membrane to the house....