Removing and pulling down wallpaper may cause severe drywall damage. Drywall nicks, dings and dents give the once-wallpapered surface a rough, uneven appearance. Adding drywall texture can repair the surface and give a unique and organic feel to the wall. Texturizing the surface often takes several days to complete. If the area is in a high-traffic portion of the home, such as a kitchen or bathroom, make a contingency plan while the project is in process.
Things You'll Need
- Drop cloth
- Painter's tape
- Drywall trowel
- Light weight joint compound
- Latex paint
- Roller frame
- Rough nap roller cover
Prepare the project area. Remove all items from the room or cover them with plastic. Clean up all the wallpaper that has been removed. Lay a drop cloth onto the floor for additional protection. Apply one-inch painter's tape to the baseboards, window frames, door frames, crown molding as well as any additional surfaces which need protection from the wet plaster. Burnish the tape by rubbing your finger, an old credit card or a plastic putty knife onto the applied tape to form a solid bond.
Texturize the surface. Use a putty knife to apply a small amount of lightweight joint compound to a drywall trowel. Hold the trowel at a 45-degree-angle and wipe on the plaster to the wall. Move the trowel around to form pits, grooves and organic shapes on the wall. Ensure the plaster is no thicker than 1/4 inch. Remember only 80 percent of the surface needs to be covered---it's OK to leave small open areas and grooves in the plaster for added interest. Allow the plaster to dry for 24 hours.
Lightly sand the surface using medium-grit sandpaper. Rub the entire surface to remove any dry wall crumbles and flakes of loose plaster from the wall. Wipe the wall with a wet sponge to remove all drywall dust created and wait for the wall to dry before painting the wall.
Use a rough nap roller and apply latex paint to the textured surface. Apply light, even pressure to the wall. Roll the wall in large vertical strokes until the surface is covered. Understand the wall may need several coats for an opaque, even coverage. Use an old chip brush to apply paint into grooves that are difficult to reach with the roller. Roll the paint as close to the perimeter of the wall as possible.
Use a trim brush to add paint to the wall's edges. Use an old brush or even a chip brush because the textured surface may be difficult to paint and can ruin a new paintbrush. Dip the brush into paint and brush around the perimeter of the wall.
Remove all tape. Use a blade or carpenter's knife if the tape is well adhered under the plaster. Slowly pull the tape up. Touch up the edge of the surface where the tape was. Use a small artist's brush to add paint to any unpainted plaster.
Tips & Warnings
- Wear nitrile or latex gloves to protect your skin from plaster and paint.
How to Skim Coat a Wall After Wallpaper Removal
Removing wallpaper can be a tedious and lengthy process. After all the paper and glue have been stripped from the wall, a...
How to Fix Drywall After Taking Down Wallpaper
After removing wallpaper, you may notice that your drywall is far from smooth. This occurs for several reasons. One is that wallpaper...
How do I Prep Walls to Paint After Removing Wallpaper?
Over time, wallpaper often begins to peel or look outdated. Although you may be tempted to paint over the existing wallpaper, the...
How to Smooth Drywall After Wallpaper Removal
Removing old wallpaper can be a chore, especially if the person who hung the wallpaper did not apply sizing before putting the...
How to Paint Over Plaster After Removing Wallpaper
Plaster becomes brittle as it ages. After removing wallpaper, you may discover that your wall looks like Swiss cheese with all the...