How to Disable Write Protection on a Scan Disk

A scan disk refers to any type of storage medium that "scans" its contents by way of magnetic storage, such as a hard drive. Disabling write protection on these devices can be accomplished by modulating the jumpers that are present on the back of the physical drives or disks. This can be done in around 10 to 15 minutes, after which time you will be able to modify the data on the drive without a problem.

Things You'll Need

• Phillips screwdriver
• Hard drive operating manual

Instructions

1. Turn off your computer and unplug it from the power source.

2. Remove the screws at the rear of the case and slide off the right-hand panel.

3. Locate the scan disk, which is at the front-bottom of the case.

4. Remove the write protection jumper from the back of the case and set it to the "write-enabled" position. Consult your operating manual for the correct position for your particular drive.

5. Close your computer, plus it into a power source and restart it.

References

• Statson: Hitachi Drive