How to Build a Wooden Prayer Bench

Man reading book.jpg

The "prie-dieu" or prayer bench has been around for centuries. Today’s prie-dieu has become a standard in chancel or “sanctuary,” furniture as a small oak frame with a sloping top and an 8-inch kneeler. The single prie-dieu measures approximately 32 inches in height, 24 inches wide and 24 inches in width. Building a prie-dieu isn’t difficult with a few skills. Stop by a cabinet shop for some oak planed and sanded to 1 1/4 inch and if you have a few tools at home, you can build a prayer bench.

1 Lay

Lay both legs out flat and make a mark 1 inch down from the top on one side. Placing a straight edge from the other top corner, draw a line across the 8-inch span to make a 1-inch slope. Cut the 1-inch slope on both pieces with a table saw or miter saw.

2 Flushing the front of the foot

Clamp and glue the 4-inch feet to the legs, flushing the front of the foot to the front of the leg forming a large “L” shape, with the slope on the top of the leg angling to the back of the feet. Drill four pilot holes each in the feet and screw them on.

3 Stand up the L with the feet

Stand up the “L” with the feet on the inside and center a stretcher between the legs at the top with one edge barely flush with the top angle. Put a bar clamp across the top and tighten slightly. Center another stretcher between the legs resting on top of the feet and place a bar clamp on the back and front of the legs, tightening slightly.

4 Corresponding with the stretchers' locations

Drill two holes in each leg 3/4 inch deep with the Forstner bit, corresponding with the stretchers' locations. Then finish pre-drilling with the 5/32 bit. Screw all the stretchers on and plug with the buttons.

5 Overhanging the back of the feet

Lay the 8-inch kneeler on the feet at the back of the “L," overhanging the back of the feet by 1/2 inch with equal overhang on both sides. Pre-drill, screw it down, and plug with buttons.

6 The top on the angle with equal overhangs

Center the top on the angle with equal overhangs on the front, back and sides of the legs, then pre-drill, screw down the top and glue in buttons. After the glue dries, chisel off the top of the buttons and sand smooth.

Specializing in hardwood furniture, trim carpentry, cabinets, home improvement and architectural millwork, Wade Shaddy has worked in homebuilding since 1972. Shaddy has also worked as a newspaper reporter and writer, and as a contributing writer for Bicycling Magazine. Shaddy began publishing in various magazines in 1992, and published a novel, “Dark Canyon,” in 2008.

×