How to Test Resistors in a Circuit

A series of in-circuit resistors
••• electronic component board 1 image by PeteG from Fotolia.com

The resistor is a vital component found in almost every imaginable electronic circuit. It shapes the electrical signal as it passes through based on the voltage and current. A bad resistor could ultimately lead to other components of a circuit failing, or the complete shut down of a circuit altogether. If you suspect a bad resistor is at the root of your electrical problems, you can conduct a simple test with a multimeter without ever removing the resistor from the circuit.

    Connect the black and red probes to the proper terminals on the face of the multimeter. The black probe is connected to the "COM" terminal on the multimeter, and the red probe is connected to the terminal marked with an ohm symbol for resistance.

    Turn the multimeter dial to the resistance setting.

    Power off the circuit containing the resistor you wish to measure. Never measure a resistor in a circuit with a live current running through it.

    Discharge any capacitors in the circuit by touching the leads of a spare, high wattage resistor to the leads of the capacitors. Keep the leads jumped for several seconds to fully discharge any stored power.

    Touch one multimeter probe to each lead of the resistor. If the leads are not accessible, touch the probes to the point where the lead is soldered to the circuit. Since resistors are not a directional component (electricity flows freely in both directions across the component) you may connect either probe to either lead of the resistor without altering your reading.

    Observe the reading on the display. A good resistor should test within its rated range. A bad resistor will either show infinite resistance or a measurement far higher than its rated resistance. In either case the resistor is no longer functioning properly.

    Things You'll Need

    • Multimeter
    • Spare resistor

    Warnings

    • Failing to remove power from the circuit or discharge capacitors could result in damage to your multimeter in addition to misleading measurements.

Related Articles

How to Test an Electrical Relay
How to Test an SCR With an Ohmmeter
How to Test a Diode Rectifier
How to Troubleshoot Single Phase Motors
How to Diagnose Amperage Draw With a Multimeter
How to Diagnose a Circuit Board With a Bad Transistor
How to Find a Short in a Circuit Board
How to Charge High Voltage Capacitors
How to Check LEDs
How to Read Amps on an Analog Multimeter
How to Check if a Diode Is Bad
How to Make a USB Powered LED Light String
How to Test a Ford 9N Ignition Coil
How to Test Multimeters
What Are the Applications of a Multimeter?
How to Lower Amperage
How to Test DC Motors
How to Test for an Open Circuit in a Home
Definition of KAIC