A broken window is a sure way to waste energy and presents a hazard to people inside and outside the home. Steel sash windows are easy to reglaze with a few simple tools and a lot of elbow grease. Technique is important to the aesthetics of the finished job, but, fortunately, you will have time to get it right.
Things You'll Need
- Double strength window glass of the proper size
- Cold chisel with a flat face about 1/2 inch wide and 6 inches long
- Bent putty knife 2 inches wide
- Safety glasses
- Silicone sealant
- Glazing putty for steel sash
- Retention clips
- Paintbrush 2 to 3 inches wide
- Plastic sheeting large enough to cover the window
- Duct tape
- Single edge razor blade or paint scraper
Close and lock the sash. Tape the heavy plastic over the inside of the window to prevent shards from spraying throughout the room. Clear the area around the outside of the window to ensure you have a clear space and solid footing. If you need to use a ladder, make sure it is solidly set.
Put on your safety glasses. Chip the old putty out of the window frame all around the glass. Start at one spot on the frame and use the hammer and chisel to get under the putty in a parallel motion. The old putty should come out in chunks. Be sure to save the retention clips. Clean the small debris and dust out of the frame with the paintbrush.
Spread a small bead of silicone sealer around the perimeter of the frame in such a way that the new glass will seat in the adhesive. Carefully press the glass into the silicone until it is flush against the inside of the metal frame. Some seepage is normal and may be cleaned up later. Install the retention clips in the frame. You should have at least one on each side.
Prepare your glazing putty by emptying the contents of the container on a hard surface. Knead the mixture like dough until it reaches a uniform consistency. It should not be sticky. Take a ball of putty in the palm of your hand and push it into the channel surrounding the window. You want to fill the space completely. It is easier to push the putty in along the length of the side than it is to push it in at a right angle.
Using your putty knife, form a triangle between the outer edge of the sash holding the glass and the inner edge of the sash that conceals the putty from the inside. This is the shape your finished putty should have. Move your knife at this angle smoothly from corner to corner. Catch the excess putty as it comes off the sash and use it to fill gaps. Make sure your corners are finished neatly and without gaps that will allow water to seep into the frame.
Use the razor blade or paint scraper to gently clean the wet silicone from the inside of the window. Do not press too hard against the glass or you will ruin your work.
Tips & Warnings
- Turn off swamp coolers or furnaces to relieve the outward pressure on the glass.
- Read the manufacturers instructions for thinning the putty.
- Paint thinner is an effective solvent for putty.
- Let the putty cure for at least two weeks before you paint it.
- Always wear safety glasses
- Regular work gloves are not adequate to protect you from glass cuts
- Follow the rule: Measure twice, cut once.
- Photo Credit Photos.com/Photos.com/Getty Images
How to Reglaze a Window
If you have ever owned or lived in a home built prior to 1960 or 1970, you probably have some experience with...
How to Glaze Metal Frame Windows
Though today's windows no longer require glazing to help keep them stable and in place, many older windows in older homes use...
How to Reglaze House Windows
As double and triple pane windows capture more and more of the market, the skill of glazing a window fades into history....