If you plan on building a deck to complement your outdoor space, you can choose to build a freestanding deck, or attach a deck to your house. Most homeowners choose attached decks, because they are more stable than freestanding decks, and because they can access the deck directly from the house. Properly attaching your deck to your house with vinyl siding will help ensure that you can enjoy your new outdoor space for many years.
Things You'll Need
- Reciprocating saw or hand saw
- Measuring tape
- Circular saw
- Pressure-treated lumber, 1 inch by 10 inch
- Carpenter’s level
- Galvanized nails
- Lag bolts, 10 inch by ½ inch
- Wrench or socket, ½ inch
- Copper flashing
- Copper nails
- Joist hangers
Remove a section of the vinyl siding with a reciprocating saw or hand saw, making sure not to cut through the subsurface of the wall. This section should be as wide as your deck, and should extend down about 12 inches from the intended surface of the deck.
Measure the thickness of your decking boards. This will determine how far below the vinyl you will place your ledger board. For example, if you are using 1-inch thick decking boards, the top of your ledger board will be 1 inch below the vinyl.
Cut a ledger board out of 1-inch-by-10-inch pressure-treated lumber using a circular saw. Make the ledger board as long as the width of your deck.
Position the ledger board on the side of the house. Use a carpenter’s level to make sure the ledger board is level. Nail the board to the wall with a hammer on both ends to keep it in place. Drill pilot holes along the top and bottom into the subsurface, and secure the ledger board to the wall with lag bolts. Tighten the bolts with a wrench or socket.
Cut a section of copper flashing as long as the width of the deck. Slide one side up at least 3 inches behind the vinyl siding. Mold the flashing over the top and in front of the ledger board. Secure with copper nails.
Install joist hangers to the ledger board. Start with the side hangers, which will hold the rim joists. Most homeowners use a double thickness of 2-inch thick lumber for rim joists, so you will likely need 4-inch joist hangers for the sides. Continue installing 2-inch joist hangers between the rim joist hangers at 12- to 16-inch intervals. Connect the joists to the joist hangers.
Tips & Warnings
- Choose premium lumber with no warping to avoid any gaps between the ledger board and the side of the house.
- Always wear eye, ear and hand protection, as well as a respiratory mask, when cutting vinyl or wood.
- Photo Credit Brand X Pictures/Brand X Pictures/Getty Images
How to Install Vinyl Z Flashing With J Molding
Z flashing is commonly used in combination with J molding or J channel to prevent water from leaking behind siding when attaching...
How to Attach a Roof Deck to a House
Roof decks require secure points of attachment to a house to survive strong winds, earthquakes and the tramping feet of guests for...
How to Attach Stairs to Your House
Stairs that attach to your home are likely to receive heavy use, whether they lead from your yard onto a deck, connect...
How to Attach a Deck to Vinyl Siding
Vinyl siding is a common material used in both new construction and remodeling. It can be applied directly over wood, plywood siding...
How to Attach a Deck Railing to a House
Railing is used for many purposes, such as a around the border of a deck or a support to help people get...
How to Attach Ledger Board
If you are building an attached deck, your first step is to attach a ledger board to the house. The ledger board...
Vinyl Railing Installation
Vinyl railing is a common choice for outside rail installations. For decks, pools or patios, a vinyl rail is durable and low...