Plan the perfect garden with our interactive tool →

How to Adjust Chain Tension on a Poulan Wild Thing Chain Saw

...
http://norwalkpower.com/index.asp?PageAction=VIEWPROD&ProdID=1497

In order for a Poulan Wild Thing chain-tension-on-the-husqvarna-55-rancher.html)-tension-on-the-husqvarna-55-rancher.html) saw to operate at peak efficiency the chain tension must be adjusted properly. If the tension is too tight the chain will bind up and not flow easily around the bar. If the tension is too loose it will sag beneath the bar resulting in poor cutting efficiency and may possibly even jump off its track creating a potentially hazardous situation. It is the nature of chains to stretch with use, particularly during the first few times you use the Poulan Wild Thing chain saw.

Put on heavy duty gloves. Insure the engine of the Poulan Wild Thing chain saw is off. Locate the bar nuts on the left side of the chain saw. Loosen the bar nuts until they are finger tight by turning them counter clockwise with the socket end of the chain adjustment tool.

  • In order for a Poulan Wild Thing chain saw to operate at peak efficiency the chain tension must be adjusted properly.
  • It is the nature of chains to stretch with use, particularly during the first few times you use the Poulan Wild Thing chain saw.

Locate the chain adjusting screw on the bar forward of the bar nuts. Insert the screwdriver end of the chain adjustment tool into the adjusting screw. Turn the adjusting screw clockwise until there is no sag in the chain beneath the bar.

Place the shaft of the chain adjustment tool into a groove behind one of the blades on the chain. Push the chain forward with the chain adjustment tool allowing the chain to roll around the bar. Insure all links remain in the bar groove.

Grasp the tip of the bar with one hand and lift the bar. Insure there is no sag in the chain. If you observe any sag, insert the screwdriver end of the chain adjustment tool into the adjusting screw again, and turn the adjusting screw clockwise until the sag disappears.

  • Locate the chain adjusting screw on the bar forward of the bar nuts.
  • Place the shaft of the chain adjustment tool into a groove behind one of the blades on the chain.

Tighten the bar nuts with the socket end of the chain adjustment tool while still holding the tip of the bar up. Use the chain adjustment tool to push the chain forward allowing it to roll around the bar. Insure the chain rotates freely. Check again for sag. Repeat steps 1 and 2 until the chain rotates freely around the bar and there is no sag.

Tip

Always loosen the bar nuts to finger tightness before attempting to adjust chain tension.

Warning

Chain blades are extremely sharp and can cut even when the chain is not moving. Always wear protective gloves when handling the Poulan Wild Thing chain saw.

Related Articles

How to Adjust the Guide Bar & Chain Tension on the Husqvarna 55 Rancher
How to Adjust the Guide Bar & Chain Tension on the...
Chainsaw Throttle Cable Installation
Chainsaw Throttle Cable Installation
How to Fix a Chain on a Black & Decker Alligator
How to Fix a Chain on a Black & Decker Alligator
How to Install a Craftsman Mower Deck
How to Install a Craftsman Mower Deck
How to Adjust the Drive Cable on a Craftsman Lawn Mower
How to Adjust the Drive Cable on a Craftsman Lawn Mower
How to Adjust a PTO Clutch on a Lawn Tractor
How to Adjust a PTO Clutch on a Lawn Tractor
Garden Guides
×