The Jeep power train control module (PCM)--or computer, as it is known in layman’s terms--controls the vehicle’s ignition, emission and fuel systems, along with other auxiliary systems necessary to the operation of the drive train. When the PCM detects a malfunction in the drive train or related systems, it will generate a trouble code that will remain until the problem is corrected or the code is cleared. In extreme cases, hard codes are generated, which can only be cleared with a proper scan tool, or by resetting the computer.
Things You'll Need
- Scan tool or battery terminal wrench
Connect the scan tool’s data cable to the data link connector (DLC) port. In most Jeeps, the DLC port is located next to the fuse panel under the driver's side dash.
Refer to the scan tool’s specific owner’s manual on how to run a self test on the PCM and clear the code. There are certain emissions-related codes that may require a Chrysler/Jeep dealership to inspect and clear. Disconnect the scan tool from the DTC port when done. If you do not have a quality scan tool, refer to Step 3.
Disconnect the negative battery cable and leave it disconnected overnight. Reconnect the negative battery cable in the morning and all but any hard codes will be cleared. By disconnecting the battery, you are essentially giving the computer a form of amnesia, whereby the computer forgets any stored codes. However, if you have not corrected the problem that caused the code in the first place, the code will return soon and the "check engine" light will come back on.
Tips & Warnings
- All scan tools are not created equal. The ones used in most dealerships cost anywhere from a few thousand dollars on up to nearly $20,000. When purchasing an aftermarket scan tool, be sure the device has the options you want, as well as the ability to work with your particular vehicle.
- Photo Credit Jupiterimages/Comstock/Getty Images
How to Clear Error Codes From a Grand Cherokee
Error codes or diagnostic trouble codes (DTCs) occur on vehicles when a sensor or component fails its intended function or fails to...
How to Reset Jeep Codes
Your Jeep's Electronic Control Module (ECM) creates and stores error codes when a fault occurs in the mechanical or electrical system. Once...
How to Reset the Engine Light in a Jeep
The check engine light on your Jeep will illuminate on the instrument panel when the on-board diagnostics computer receives an error code...
How to Reset the Airbag Light on a 1999 Jeep Grand Cherokee
The airbag light illuminates on the instrument panel of your 1999 Jeep Grand Cherokee when there is a problem with the airbag...
How to Reset the Fault Code on a Jeep Cherokee
The Jeep Cherokee's engine includes a computer that monitors several sensors. If a sensor reports a problem, the computer will display the...
How to Reset the Computer in a Jeep Cherokee
You can reset the computer in your Jeep Cherokee from your home garage, saving yourself time and money. The PCM (power train...
How to Reset Jeep Wrangler Codes
You can reset your Jeep Wrangler's trouble codes right in your driveway if you have a socket set. The engine control module...
How to Reset the Anti Theft on a Jeep Cherokee
The Cherokee is among the many Jeep vehicles that offer keyless entry and anti-theft systems. The Jeep's remotes allow you to control...
How to Reset the Alarm on a 2002 Jeep
Jeep makes a number of rugged vehicles, such as the Wrangler, Grand Cherokee and TJ. In 2002, some Jeep models used a...
How to Install an ECM in a 1998 Jeep Grand Cherokee
Believe it or not, there was a time when the mere idea of fuel injection very nearly caused a riot in Jeep's...
How to Reset PCM
The programmable control module, or in some vehicles, the engine control module or ECM, stores codes when one of the sensors malfunctions...