How to Dry Soaked MDF Floorboards

Save

Medium-density fiberboard, or MDF, is a wood product manufactured by breaking down scraps of soft or hardwood, mixing them with wax or resin, and baking and pressing them into a dry, boardlike shape. MDF is much cheaper than natural wood products, but is heavier, not as strong in most cases, and highly susceptible to water damage. MDF can only be dried out if it is not exposed to water for a very long time, and in most cases it will be warped by even short exposures.

Things You'll Need

  • Dry Mop
  • Absorbent cloths
  • Heat gun
  • Portable fans
  • Use a dry mop and absorbent pieces of cloth or even paper towels to get the water out of the particle board as quickly as possible. The longer the water sits in the board, the greater the damage will be, and in some cases the board may start to break down if it soaks too long. Also, keep in mind that a thoroughly soaked board will be warped, even when completely dry again.

  • Set up fans all around the area to move as much air as possible over the boards, which will help pick the moisture out of them.

  • Use a heat gun (or hair-dryer if you don't have a heat gun) to dry out the boards even faster by slowly and evenly passing it back and forth over the wet boards. Make a pattern like you're mowing a lawn, back and forth in alternating directions as you move along, and when you've gone over all the areas start again from the beginning. You want to dry the boards quickly but evenly so as not to warp them even more than they will be already.

Tips & Warnings

  • A better, though more expensive option than the above would be to rent a heat-drying system, which will be able to pump a lot more hot air for a longer amount of time than a heat gun combined with fans. The basic principles are the same though: Warm the air so it can pick up more moisture, and keep it moving over the wet floor.

References

  • Photo Credit Hemera Technologies/Photos.com/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Clean Up Moldy Carpet & the Floorboards Underneath

    Moldy carpet and floorboards can cause a host of health problems for home occupants. Allergies and compromised immune systems may develop if...

  • How to Burn Particle Board

    Particle board is a very inexpensive alternative to natural hardwood or pressed plywood. It is sturdy under most conditions, but once it...

  • How to Seal MDF

    MDF, commonly referred to as particle board, can be a difficult material to work with. Its very nature--compressed wood particles and wax--makes...

  • How to Keep a Fastener From Tearing Out of MDF

    Medium density fiberboard (MDF) is a plywood substitute made of a mixture of wood chips and glue. Like plywood, it comes in...

  • MDF Exterior Uses

    MDF, also known as medium density fiberboard, is a manufactured composite, similar to particle board. It is made from synthetic resins, binders...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!