Harley-Davidson adjustable push rods allow for the use of non-stock or performance cams. These types of cams will have different profiles than the stock cams with variations in lift and base circle diameter. Stock, non-adjustable push rods will likely not be the right length for use with the new cams. Adjustable push rods are set to the proper length with a few basic tools.
Things You'll Need
- Bike lift
- Clothespins (4)
- Wrench set
Raise the bike with the bike lift. Place the bike lift close to the rear of the frame so that the bike is supported with the rear wheel off the ground. Put the transmission in first gear.
Remove all four push rod cover clips by hand or with pliers if they are stubborn. Use caution and do not bend or ruin the finish on the clips. Pull the upper and lower push rod covers from their recesses in the head and block, respectively. Inspect the push rod tube O-rings for damage and deformities.
Hold the covers up to expose the adjusters. Push the covers up and clip a clothespin to the push rods to hold the covers in place.
Roll the rear wheel until the rear exhaust valve cam is in the Open position or when the maximum lift on the rod is detected. Now you can adjust the front exhaust push rod.
Extend the adjuster on the front exhaust push rod until the rod can spin freely but has no up-and-down slack. Tighten down the lock nut with wrenches (most likely 5/16 and 3/8 inch, but this may vary by push rod manufacturer). Recheck the adjustment once the lock nut is tight.
Roll the rear wheel until the rear intake cam is at maximum lift. Adjust the front intake push rod at this time. Repeat this process until all four valves are adjusted.
Put the O-rings back into their recesses. Carefully extend the upper and lower push rod cover tubes back into their recesses. Reinstall the push rod cover clips by hand.
Tips & Warnings
- Always roll the rear wheel as it would roll if you were moving forward. Never rotate the engine backwards. The geometry of the internal parts is not designed to allow for reverse rotation, and serious damage may occur.
- Photo Credit Justin Sullivan/Getty Images News/Getty Images
What Does FLH Mean on a Harley Davidson Motorcycle?
The Harley-Davidson FLH motorcycle, manufactured by the Milwaukee-based Harley-Davidson Motorcycle Company, originated in 1949 as the Hydra-Glide touring model, so named for...
How to Remove Push Rod Covers from a Harley Davidson
Many motorcycle riders today are finding that a good do-it-yourself attitude is valuable in keeping their motorcycle on the road and more...
How to Calculate Pushrod Length
Modern automotive and lubricant technology has created engines that barely need to be touched, except for oil changes. A certain breed of...
How to Adjust the Brake Master Cylinder Pushrod
The master cylinder pushrod runs from the master cylinder, through the brake vacuum booster, through the firewall, and attaches to the arm...
How to Adjust Valves on a Shovelhead Harley Davidson
Motorcycle pushrods link the cams to the valves, the primary components of the engine. Valves require adjustment over time due to wear....
How to Adjust the Chain on a Harley Motorcycle
Older Harley-Davidson motorcycles (1990 and older) use a chain for the final drive. Some newer models also use a belt drive but...
How to Install a Harley Valve Lifter
Most Harley Davidson models come equipped with a solid lifter, or pushrod, assembly, having an adjuster built in. For instance, the Harley...
How to Replace Harley Pushrods & Lifters
Maintaining your Harley-Davidson motorcycle entails correctly tuning the bike's components in order to keep it safely running on the roads. Many motorcycle...
How do I Install 2001 883 Harley Sportster Push Rods?
Pushrods, on the exterior of the cylinders on the right side of the engine, are part of an old-fashioned connection between the...