How to Put On a Wood Shingle Roof

Save

Wood shingles are typically made of cedar. They are strong, durable, shed water well and deflect heat better than composition shingles. Using wood shingles on your home can give it a distinctive look and add value. You can hire a professional to put on a wood shingle roof or do it yourself. Choosing to install wood shingles can be a moderately difficult project and take a couple of days to complete. The job will require proper supplies and good instructions.

Things You'll Need

  • Shingles
  • Chalk line
  • 3d galvanized nails (for 16- and 18-inch shingles)
  • 4d galvanized nails (for 24-inch shingles)
  • Utility knife
  • Piece of one-by
  • Circular saw
  • Double-check your supplies and instructions. Make sure you have everything you need before you step onto your roof. It will be a waste of time to start your wood shingle roof, only to stop because you are missing supplies.

  • Lay down your first shingles. Take two shingles and place them at the eaves, putting one on each end of the roof. Position the shingles so they hang over the eaves by 1 inch and hang over the rake by 1/4 to 3/8 inch. Eaves are the horizontal edge of the roof and the rake is the side edge.

  • Install a starter row of shingles. Hammer one nail into the shingles you just put down at the eaves. Use your chalk line to make a line between the two shingles. Use this line as a guide to keep your starter row straight. Begin laying shingles along the line between the shingles at the eaves. Use two nails to attach each shingle to the roof. Hammer nails ¾ inch from each edge and 3 to 4 inches up from the bottom edge.

  • Install more rows of shingles. Use a chalk line if needed to keep your rows straight. Leave between 1/8 and ¼ inch between each shingle because the wood will naturally expand. For each new row, don’t let the spaces between them line up with the spaces between shingles directly below. Stagger the spaces by 1½ inches. Use two nails for each shingle like you did with the starter row.

  • Cut shingles for the roof valley. Count the number of shingles you’ll need for the valley. Align the butt of one sample shingle with the eaves and mark the roof angle with a pencil. Get off the roof, get your circular saw ready and cut out the sample shingle. Cut all other valley shingles to match your sample shingle.

  • Attach valley shingles using a guide. Take the piece of one-by and place it in the valley. Do not nail it in place. Take the shingles you cut out, place them in the valley next to the piece of one-by. Nail them to the valley the same way you did other shingles. Let the last one hang over the roof ridge. Mark it with a chalk line where it meets the ridge. Use your utility knife to score the shingle at the line and press down gently on the shingle so that it snaps in two. Discard the part you broke off.

  • Put shingles on hips and ridges. Use shingles designed for these areas and attach as you did with other shingles.

Tips & Warnings

  • Make sure your ladder is sturdy. Check with local officials to see if you need a building permit. Ask someone to help you.
  • Do not touch power lines or antennas and don’t allow a metal ladder to touch them. Remember to wear rubber-soled shoes so you won’t slip and fall.

References

  • Photo Credit Comstock/Comstock/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Make Wooden Shingles

    Wooden shingles provide a distinctive look. One of the benefits of using wood around the home is the additional insulation wood naturally...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!