If you are laying a sprinkler system, drainpipe or electricity lines, you may need to lay pipe underneath a sidewalk. This makes it necessary to bore a hole under the sidewalk, instead of breaking up the cement to lay the pipe. Horizontal boring or tunneling under concrete sidewalks is done easily by hydraulics.
Things You'll Need
- PVC pipe
- Male hose end adapter
- Female hose end adapter
- PVC glue
- Garden hose
- High-pressure nozzle
- Duct tape
- Eye protection
- Yard faucet
- PVC cutters
Make a tunneling pipe (sometimes referred to as a boring rod) with a high-pressure nozzle (a nozzle made of metal with a small opening works best). These items are available in home improvement stores or irrigation supply stores. A tunneling pipe can be made of polyvinyl chloride plastic pipe (PVC) with a PVC male hose end adapter glued on one end and a female hose end adapter glued on the other end. The PVC pipe should be either 1/2 inch, 3/4 inch or 1 inch in diameter.
Dig a trench up to both sides of the sidewalk to approximately a foot in depth. You will start boring at about 6 to 8 inches below the sidewalk.
Put on eye protection. Cut the PVC pipe to 2 feet longer than the sidewalk. Glue the male and female hose end adapters to the PVC pipe. Screw the high-pressured nozzle to the male hose end adapter, and the garden hose to the female hose end adapter (this PVC pipe will now be referred to as the tunneling pipe). Tape, with duct tape, whatever it is you want under the sidewalk--such as electrical wiring encased in PVC pipe (cap each end so you won't get dirt in it; remove caps later)--to the tunneling pipe. If you are planning on using the PVC pipe for a sprinkler system, you can just leave the tunneling pipe under the sidewalk for that purpose. If you are boring for a larger pipe, such as a drainpipe, just make the tunnel large enough to push a pipe through.
Lay the tunneling pipe in the trench with the nozzle ready to spray under the sidewalk. Turn on your garden hose. The force of the water will start to hydraulically bore a hole under the sidewalk.
Push the hose nozzle farther under the sidewalk as the hole gets bigger. You may have to use the hose end to bore out more dirt by thrusting the nozzle in and out under the sidewalk. Keep spraying the water and boring under the sidewalk until the tunneling pipe breaks through on the other side.
Remove the garden hose. Cut off the nozzle and the male and female adapters with PVC cutters or a hacksaw.
Tips & Warnings
- Wear eye protection in case small rocks dislodge and fly up toward your face.
- Photo Credit Jupiterimages/Creatas/Getty Images
How to Put Pipe Under a Driveway
The installation of sprinkler systems, electrical conduit or gas lines frequently requires excavating underneath driveways or other sections of pavement. Homeowners without...
How to Install a Drain Under a Sidewalk
When a sidewalk crosses the path of where you want to install your drain pipe, you can either dig up the sidewalk...
DIY Horizontal Boring
Horizontal boring machines are used to install pipes and conduits into the ground under objects that are too expensive to dig up...
How to Run an Electrical Conduit Under a Sidewalk
Running electrical conduit under a sidewalk can be a relatively easy project with the right tools and a little knowledge. There are...
How do I Cut a Downspout Into the Sidewalk?
It is essential that downspouts extend a few feet from your home to keep water from flooding the foundation. If you are...
How to Bore Under a Drive
Occasionally, renovation projects require placing irrigation pipes or electrical wires under a driveway. Digging a trench through the driveway is difficult and...
How to Install a Sprinkler under a Driveway
When an in-ground irrigation system is installed, it often happens that the line will need to cross a solid surface, such as...