How to Make a 5-Gallon Bucket Seat

Save

Those 5-gallon buckets that hold construction and painting supplies can be salvaged or purchased new from the hardware store. They are a ready-made, inexpensive way to add seats to a classroom or your home playroom art table. Paint the buckets to cover up commercial logos and to match your decor and use bright, tough fabric or colorful, vinyl-coated tablecloths to upholster them.

How to Make a 5-Gallon Bucket Seat
(Kathy Burns-Millyard/Demand Media)

Things You'll Need

  • 5-gallon bucket and lid
  • Vinyl spray paint
  • Painter's tape (optional)
  • Heavy cardboard or thin plywood
  • Pencil
  • Craft knife
  • Jigsaw (optional)
  • Industrial-strength glue
  • Staple gun
  • Upholstery foam
  • Ribbon (optional)
Step 1

Remove the lid from the bucket. Leave the handle on or take it off permanently -- your choice. If you keep the handle on, paper or tape it so it stays paint-free. Paint the bucket on the outside, including the rim and the bottom. Paint just the rim of the lid. Let the paint dry.

Kathy Burns-Millyard/Demand Media
Step 2

Trace the bucket lid on a piece of heavy cardboard or thin plywood and cut out the circle, using a craft knife or a jigsaw, depending on the material.

Kathy Burns-Millyard/Demand Media
Step 3

Trace the bucket lid on a piece of dense thick foam -- choose your foam height for seating comfort and practicality. Two inches may be fine, while 4 inches could be very comfortable, but might not fit under small tables. Cut the foam slightly outside the traced perimeter line. Glue the cut-out foam to the circle of cardboard or plywood.

Kathy Burns-Millyard/Demand Media
Step 4

Cut a piece of stain-resistant fabric or a vinyl-covered tablecloth 3 to 4 inches bigger around than the bucket lid.

Kathy Burns-Millyard/Demand Media
Step 5

Place the glued foam and base, foam-side-down, in the middle of the wrong side of the fabric. Pull the fabric up over the foam and base and secure it to it, stapling one section at a time and swiping a bit of glue on the base before stapling the fabric to it. To keep the cushion even, work on one side, then its opposite, alternating sections and pulling the fabric taut as you go around.

Kathy Burns-Millyard/Demand Media
Step 6

Trim excess fabric from the underside of the cushion base. Coat the top of the bucket lid with a generous amount of industrial glue, following the manufacturer's instructions for letting the glue become tacky. Place the cushion on the lid and let the glue bond the cushion and lid together.

Kathy Burns-Millyard/Demand Media
Step 7

Put the lid back on the bucket. You could decorate the bucket with cut-out shapes or tie bright, sturdy ribbons on the handle, if you left it on the bucket. Use cushioned bucket stools for primary or nursery school seating in the classroom or at home.

Kathy Burns-Millyard/Demand Media

References

Promoted By Zergnet

Comments

Resources

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!