How to Make Your Own Washer Game Boards, Washers bullseye

Washers, a popular game at camp outs, and get togethers. Where do you get these. Most people make them. Here is some directions that will help you make your own.

Instructions

1. Make 2 frames. Cut cut a 2x6 4 feet long. Measure up on each end 1 1/2 inches from one side and 3 1/2 inches from other. Dothis on each end opposite sides. Draw line from 1 1/2 end to 3 1/2 end so you can cut 2 tapered pieces out of board. Cut a 2x4 13 inches long. cut a 2x2 13 inches long. Screw the tapered pieces into the 2x4 and 2x2 on ends they are flush with. Make 2 of these all steps.

2. Cut 2 pieces of 3/4 inch plywood 48 inches long by 16 inches wide. Screw these pieces on to frames. Mark a line at 8 inchs down the entire 48 inches of plywood. Measuring down the 48 inches mark on line at 12, 24, and 36 inches. Using a hole saw drill 4 inch holes centered on your marks.

3. Take two 58 inch pieces of indoor outdoor carpet 28 inches wide and rap the game boards with it. Tack this with staples on bottom side. Cut holes out in star and fold through and tack on back side. You have your boards for your washers game.