How to Repair Submersible Pumps

Submersible pumps sit in the fluid to be pumped. This can be drainage, sewage, slurry pumping, and general industrial pumping. When purchasing a pump, examine the equipment before accepting it. For troubleshooting help, follow several tips and consult your owner's manual.

Instructions

1. Check the water level and relay times if the pump is not delivering water. The water level may be too low. A connection leakage may also be the problem. If so, disassemble the connection pipes and replace or reconnect if they are not damaged.

2. Check the gate valve, it may be closed. If it is closed, open it. Check the non-return valve to see if it is blocked. If it is blocked, replace the valve.

3. Check for presence of gas in the pumped liquids if your pump is vibrating or making noises. If so, apply competent well-drillers. Wearied bearings and bushes may also be the problem. If they are worn, disassemble and replace the parts.

4. Check the power if the engine refuses to start, it may simply be turned off. Rest the starter if it has been turned off. The pump may also be sand-locked. If that it the case, call the dealer, remove the pump and clean.

Tips & Warnings

• Speak with an associate at your local hardware store or a major hardware store regarding any questions with your submersible tank.

• Always disconnect power before beginning to trouble-shoot and refer to your owner's manual.

References

• Franklin-Electric

Resources

• Read this Article in Spanish