How to Cut Roller Blinds
Window blinds come in many types that roll or pull down to cover window; some are pleated and use a pull cord. Each type of shade is mounted on a bracket near the top of a window. These blinds can be reused in a different window but may not be the correct width and need to be cut to size. You can cut a roller blind by first determining the width that is needed for the blind. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Measure the width of the window opening with a tape measure.
-
2
Transfer the measurements to the window shade and make a mark with a pencil where you will need to cut the blind.
-
-
3
Roll out the blind and place it on a flat surface, such as the floor or a workbench.
-
4
Use a tape measure to measure the amount of the fabric shade that needs to be cut off of one end.
-
5
Make two to three marks down the length of the shade with a pencil.
-
6
Place the straight edge over the marks you made and cut the fabric along the straight edge with a utility knife.
-
7
Close the shade and cut the end of the head rail and valance, if necessary, with a hacksaw along the cut end of the fabric shade.
-
8
Remove the cap from the small end of the blind with pliers and then place the cap on the end of the newly cut shade.
-
9
Mount the shade in the window to complete the project.
-
1
Tips & Warnings
Trim kits can be purchased; they include a tape measure and utility knife.
Cutting the fabric of the shade without using a straight edge may leave a cut that is not straight.
