Tile can be installed in many places inside and outside the home, including a deck, as an alternative to sanding and staining or painting. Installing tile over a deck over decking is similar to installing tile over a wood sub floor. Any tile that is installed over wood beams will require a flat surface for the tile. You can install tile over decking by first using an underlayment or backer board on the surface of the deck.
Things You'll Need
- Plywood backer board
- Waterproof membrane
- Utility knife
- Staple gun
- Table saw
- Tape measure
- Power drill
- Tile spacers
- Tile float
Measure the width and length of the deck with a tape measure to determine how many sheets of plywood backer board will be needed to cover the deck. Sheets of plywood typically measure 4-feet wide by 8-feet long. Divide the width by "4" and the length by "8" to find the number of plywood sheets you will need. Measure and cut the plywood to fit areas where a full sheet will be too big. Transfer the measurements to a sheet of plywood and make a mark with a pencil. Cut the sheet of plywood along the pencil mark with the table saw.
Lay the sheets of plywood on the decking and attach them using screws and a power drill. Place the screws 6 to 8 inches apart when securing them to the decking.
Lay the waterproof membrane over top of the plywood backer board. The waterproof membrane will keep water and moisture from damaging the plywood backer board. Secure the membrane to the plywood backer board using a staple gun. Place staples every 6 inches over the entire area of the deck. Cut the excess membrane around the edges of the deck with a utility knife.
Apply mortar over the waterproof membrane using a trowel. Mix the mortar in a bucket with water by following the instructions on the package of mortar mix. Place a small amount of mortar on the waterproof membrane with a trowel and spread it out.
Drag the edge of the trowel with the grooves at a 45-degree angle to create notches in the mortar.
Place the first piece of tile on the mortar and press down to create a secure bond. Place the second piece of tile next to the first one. Insert a tile spacer between the tiles. Repeat the previous three steps to finish laying the tile over the deck.
Wait for the tile to dry. Apply grout to complete the installation. Place grout on a section of the tile and pull with the grout float to fill in the grout lines.
How to Install a Deck
A deck can give you enjoyment for as long as you own your house. As an added bonus, when you are ready...
How to Put Ceramic Tile on a Wood Deck
Is the wood on your outdoor deck fading and losing its appeal? You can cover your wooden deck with tile, as long...
How to Install Composite Decking Over Wood
When decks are exposed to extreme sunlight or abundant rainfall, the decking boards can wear out long before the deck's foundation. You...
How to Install Rubber Deck Tiles
No matter the outside surface, whether it's the concrete slab of most patios, brick or clay pavers, or even the wood of...
How to Lay Tile Outside on a Wood Surface
If you've got a screened porch, covered deck or other area with an outdoor wood surface, and you're looking for a way...
How to Lay Tile on a Wood Deck
Although wood decks are naturally aesthetically appealing, weather exposure causes them to look dingy over time. Deck tiles instantly improve an old...
Can I Put Tile or Linoleum on My Wood Deck?
When you're remodeling your outdoor wood deck with a new surface after the old one has faded or you just want a...