Lightweight concrete, also known as EPScrete (expanded polystyrene concrete), is a material widely used in the building of environmentally "green" homes. The substance is often made using small Styrofoam balls as a lightweight aggregate instead of the crushed stone that is used in regular concrete. While it isn’t as strong as stone-based concrete mixes, it has several advantages over the more traditional mix. EPScrete has increased insulation properties, and because it's up to 88 percent lighter than stone-based concrete, it has smaller structural support needs such as foundation sizes and steel reinforcement requirements.
Things You'll Need
- 94 lb. bag Portland cement
- 5 gallon bucket of sand
- 5 gallons of water
- 5 (5 gallon) buckets of Styrofoam beads of various sizes
- Concrete mixer
Place 5 gallons of water into the concrete mixer. Add in any additive or colorant you wish to use in the concrete, and mix the add-ins thoroughly with the water.
Add half a 94 lb. bag of Portland cement to the mixer as well as the 5 gallon bucket of sand. Mix thoroughly with the water, creating a mix that’s soupy in texture.
Add one of the 5 gallon buckets of Styrofoam beads. Mix for a full minute to allow the beads to absorb the water before adding additional buckets of Styrofoam.
Continue adding the Styrofoam, taking the time to mix in each bucket after the addition to the cement mixture. The Styrofoam will quickly absorb the water in the mix. If the mix becomes too stiff to incorporate the beads, add additional water as needed.
Stop mixing the concrete when all the Styrofoam has been absorbed. The mixture should be of a low-slump variety, pourable but not overly soupy.
Pour the mix into molds or forms and place on a level surface covered with plastic film to begin curing. If using as a slab or wall material, pour directly into place and leave it to cure.
Remove the cement from the mold after 24 hours and allow the EPScrete to complete the curing process. Curing should take a full month, and the stone will need to be kept damp during the process in order to allow full strength bonding to occur.
Tips & Warnings
- For a stronger concrete, increase the sand used and decrease the Styrofoam by the same amount.
Types of Glue for Styrofoam
Styrofoam is used in many craft projects, everything from floral arrangements to models to costumes and play sets. One of the challenges...
How to Make Styrofoam Cement
Adding Styrofoam to cement instead of gravel is a great way to make a lightweight solution and recycle some of that excess...
How to Install Styrofoam Basement Forms
Styrofoam insulated concrete forms are growing in popularity. They are used in basements to provide ample insulation and space to run utilities....
How to Glue Styrofoam to Concrete Walls
Bare concrete walls are usually an unpleasant thing to have in any home or building; they are bad at retaining heat and...
How to Make Homemade Lightweight Concrete
Create lightweight concrete by altering the standard concrete mix ratio, substituting a lightweight additive to the mix for a portion of sand....
How to Make a Lightweight Concrete Statue
Concrete statuary can be found at most garden centers or home stores. You can use concrete statues as accent pieces for your...
How to Cement a Styrofoam Wall
Styrofoam often has uses in home improvement applications. It is an ideal insulator because of the many small air pockets inside it...
How to Make My Own Urethane Foam Product
Urethane foam comes in two forms. Soft urethane foam is flexible and used to make items such as car seats, soft props...
Comparison of Concrete and Foam Building Blocks
Builders and homeowners are always looking for ways to save money. They also look to reduce anxiety about the resale value of...