How to Cut Laminate Floor Around Heating Vents

Save

You're ready to install your laminate floor, but you're a bit perplexed: You aren't sure how to cut the flooring around the heating vents. You'll be relieved to learn that there's a simple process to follow and you'll be able to make the needed cuts in minutes. The key to keep in mind is that laminate flooring is installed via a floating floor method, and you need the float allowance beneath the heating vent covers.

Things You'll Need

  • Jigsaw
  • Remove the cover from the heating vent. The cover typically pulls straight up from the floor. Set it aside; you can use the same vent cover after the flooring is installed.

  • Install the last row of flooring up to the heating vent opening.

  • Measure the opening in the floor and transfer the measurements to the plank or planks that will cover the opening.

  • Mark your cutting line 1/4 inch around the vent opening measurement on the plank; this will allow for the required expansion space for the floating floor. If no expansion space is left, the laminate will eventually buckle in this area when it expands from heat and humidity.

  • With a jigsaw, cut the plank along the markings made from the vent measurements.

  • Fit the cut plank into the next installation row, and continue your flooring job as before.

  • Replace the vent cover when your installation is complete. The outside edge of the cover that lies on the floor will hide the cut edge of the plank and the 1/4-inch expansion space.

Tips & Warnings

  • Always wear eye protection when using cutting tools.

References

Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!