There are two basic ways to wire two or more light fixtures together -- in parallel and in series. Most homes feature parallel wiring. Parallel wiring allows the other lights in the circuit to remain in working condition when one goes out, whereas series circuits are similar to a string of Christmas lights: When one goes out, they all go out.
Things You'll Need
- Wire strippers
- Needle-nose pliers
- Voltage tester
- Wire connectors
- Electrical tape
- NM cable
- Romex stripper
Turn off the breaker that powers the circuit you will be using to feed the two lights.
Bring the feed line into the wall box where the switch will be located.
Run NM cable from the switch box to the first light fixture. Then run another line going from the first light fixture to the second.
Use the Romex stripper to cut and remove the outer sheathing on all of the cables. Then, use the wire strippers to strip about 3/4 inches of insulation from the end of each insulated wire.
Starting at the second light fixture, connect the black ceiling wire with the black wire on the fixture and the white ceiling wire to the white fixture wire; then connect the ceiling ground wire with either the fixture's ground wire or the fixture's ground screw.
Make sure each wire connector is tightly twisted over the wires and covers the connections with a piece of electrical tape. Stuff the wires back into the ceiling and mount the fixture to the ceiling box, as directed by the fixture's instruction.
Move to the first fixture in the line and make the following connections:
- Connect the two black ceiling wires to the black fixture wire.
- Connect the two white ceiling wires to the white fixture wire.
- Connect the two ground ceiling wires to the ground wire on the fixture, or tie them together with a pigtail, which will then get connected to the ground screw on the fixture.
Move to the wall switch and make the following connections:
- Connect both white wires together.
- Make a pigtail connection with the two ground wires and connect the ground pigtail to the green grounding screw on the switch.
- Connect the black feeder wire to the bottom terminal on the side of the switch, and the black wire that's traveling to the fixture to the top screw terminal.
Wrap the switch's terminals with electrical tape, secure the switch to the wall box and install the cover plate.
Turn the circuit breaker back on and test out your installation.
Tips & Warnings
- Never work on an electrical circuit while the power is on. Always turn the circuit off at the electrical panel before proceeding.
Benefit of Connecting Light Bulbs in a Series
When purchasing Christmas lights, one issue that many shoppers don't know to consider is whether their lights are in series or parallel....
Series Vs. Parallel Circuit for Christmas Lights
Christmas lights add a festive environment to your home or business during the holidays. They can adorn your Christmas tree inside or...
How to Wire Four Lights on One Switch
Wiring four lights on one switch, or daisy chaining as it is also called, is an efficient way to control lighting for...
How to Wire a Light Socket in Series
Light sockets are typically wired to a switch to allow the light to be turned on and off. The light socket is...
How to Wire LEDs in a Series
LED--light-emitting diode--lights can be wired in series or parallel. Wired in series, the supply voltage is divided between the LEDs. Connected in...
Why Are House Lights Wired in Parallel?
Parallel wiring is a type of circuit used to supply electricity to multiple appliances, using one energy source. The advantage to wiring...