How to Join Flex Duct

Save

The inner sleeve of flex duct is either a thin plastic membrane supported with an integrated wire or lightweight ribbed aluminum. Both types of inner sleeves require support when connected together; you cannot insert one end of the flex into the other. This will result in a weak connection and will obstruct the airflow through the flex duct. You need to add a third component to strengthen the connection, and provide an anchoring point for the tie-down straps used to secure the flex duct inner liners.

Things You'll Need

  • Flex duct knife
  • Wire cutters
  • Four-inch long metal sleeve matched to the diameter of the flex duct
  • Tape measure
  • Permanent marker
  • Two large tie bands
  • Banding tool
  • Duct tape
  • Roll back the insulation and outer covering of the flex duct to expose the inner liner on both pieces of flex you need to join.

  • Cut the inner liner of the flex square using the flex knife. Trim the excess wire that projects from the inner liner. Perform the same operation on the inner liner of second piece of flex that you need to join.

  • Place a center mark at four points of the metal sleeve by measuring 2 inches in from either end of the sleeve with the tape measure and permanent marker. Make sure that the marks are equidistant around the metal sleeve.

  • Slide the metal sleeve into the inner liner of one of the pieces of flex duct. Stop sliding the sleeve when the inner liner reaches the center marks you placed on the sleeve in the previous step.

  • Wrap a tie strap around the flex duct inner liner and the metal sleeve. Hand tighten the tie down to hold the inner liner to the metal sleeve.

  • Align the inner liner with the four center marks located on the metal sleeve.

  • Tighten the tie band with the banding tool.

  • Slide the inner liner of the second piece of flex on the metal sleeve. When the two inner sleeves meet, secure the inner liner of the second flex with another tie band and banding tool as described in step seven.

  • Unroll the insulation and outer covering of both pieces of flex. Ensure that the insulation overlaps.

  • Tuck the outer covering of one piece of flex under the outer covering of the other piece of flex.

  • Wrap duct tape around the area where the cut edge of the outside covering rests on the other piece of flex to seal the connection.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Seal Air Ducts

    You can lose hundreds of dollars a year in utility bills because your air ducts are not sealed properly. But leaky ducts...

  • How to Join Rectangular Ducting

    Installing rectangular duct work requires care. Care must be taken to ensure the duct sections are properly joined together in order to...

  • How to Join Together Two Pieces of Corrugated Flexible PVC Hose

    Corrugated flexible PVC piping is often used in outdoor projects, or as plumbing in spas or swimming pools where there is not...

  • How to Join Metal Ductwork

    Metal residential duct systems are fabricated using light-gauge galvanized steel. Home systems are usually low-pressure,1/2-inch water gauge with air movement measuring less...

  • Flexible Ducting Vs. Solid Ducting

    Duct systems are used to distribute air from a central fan system to various areas of a home or business. Sometimes there...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!