How to Install Self-Adhesive Flashing Tape

Save

Self-adhesive flashing tape is used in the installation of windows and doors to seal the seams and prevent moisture damage. Flashing needs to be properly installed to keep water from getting into the walls. Self-adhesive flashing tape will stick to most building materials and seal around holes made by nails and screws. Flashing tape typically comes in rolls that are four inches, six inches or nine inches wide. Flashing tape is installed after the sill pan flashing and window has been set into the rough opening.

Things You'll Need

  • Self-adhesive flashing tape
  • J roller
  • Utility knife
  • Cut the corners of the house wrap--the plastic sheeting that goes underneath the house siding--above the top ledge of the window at a 45-degree angle to make a flap. Fold the flap up and tape it up to temporarily keep it out of the way.

  • Cut flashing to fit along the sides of the window with a sharp utility knife. Cut the flashing so that it is long enough to overlap the sill pan flashing and so that it extends two inches above the top of the window. The sill pan lining is the rigid flining that is installed under the window before setting it into the rough opening.

  • Affix the side flashing. Starting at the top, set the tape against the side of the window and gradually work your way downward. Remove the backing from the tape as you go. Use your hand to smooth down and adhere the tape as you go. Make sure at the bottom ends of the sides, the flashing overlaps the sill pan lining.

  • Cut the header flashing; make sure it is long enough to overlap the extended ends of side flashing.

  • Affix the header flashing. If your window has a drip cap, this should be installed beforehand so that it can also be sealed by the flashing. Make sure that the ends of the header flashing are completely overlapping the top ends of the side flashing.

  • Make sure that all of the flashing tape is laying flat and that there are no gaps or bubbles by going over it with a J roller.

  • Pull the house wrap flap from above the window down and over the flashing.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Install an Aluminium Window

    When installing an aluminum window yourself, there are several steps that need to be followed so that the window will operate properly....

  • How to Install House Windows

    The hardest part about installing new windows is taking the old ones out. It's very popular to install new windows to be...

  • How to Install Window Flashing

    Window flashing is installed around each window in order to prevent water from entering into the various gaps around the edges. If...

  • How to Install Plastic Sheeting Over Windows

    Drafty windows make us uncomfortable during cold weather and really uncomfortable when the heating bill arrives. It's easy to install plastic sheeting...

Related Searches

Check It Out

Geek Vs Geek: Robot battles, hoverboard drag race, and more

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!