A doorknob is the handle used to open and close doors. On most doors, you have a doorknob on both the inside and the outside so you can operate the door from either direction. When you need to replace a doorknob, you might find the existing doorknob hole is simply too small. That means you'll need to enlarge a hole for the doorknob before you can install your new knob.
Things You'll Need
- ½-inch thick plywood
- Doorknob template
- Hole saw
- Tape measure
Cut a ½-inch thick piece of plywood so it's six inches wide and eight inches long.
Place your new doorknob template, which should be included with your doorknob set, on the piece of wood. Mark the appropriate areas of the template onto the plywood.
Use a hole saw to drill through your piece of plywood to create your own wooden template.
Measure the backset on your existing doorknob hole. The backset measures the distance between the edge of the door and the center of the existing doorknob hole. It should be either 2 3/8-inches or 2 3/4-inches.
Clamp the plywood template to your door so it's in the exact position where you need to enlarge the doorknob hole.
Before you drill with your hole saw, make sure you have the same backset as you measured previously, either 2 3/8-inches or 2 3/4-inches from the edge of the door. This will help ensure the hole in the guide is the correct distance from the edge of the door.
Drill about half way through the door using your hole saw.
Position your plywood template on the other side of the door. Make sure you have this template exactly opposite where you drilled in Step 7. Drill again with your hole saw until the two holes meet in the middle.
Tips & Warnings
- If the doorknob hole is only slightly too small for your new doorknob, use a small course file to file down the area you need enlarged.
How to Reduce an Enlarged Screw Hole
A stripped screw hole can bring any home improvement project to a sudden stop. Whether you're installing hinges, mounting a mirror or...
How to Fix a Stripped Screw Hole
How to Fix a Stripped Screw Hole. We've all had the problem of a screw getting pulled right out of a hole...
How to Enlarge an Existing Hole in Woodworking
Woodworking projects often require many various sizes of holes. When you discover that a hole you're working with isn't big enough to...
How to Fix Cabinet Door Knobs
It is frustrating and occasionally dangerous when cabinet door knobs pull off as you try to open the cabinet. Fortunately, repairing them...
How to Install a Dummy Door Knob on a Pre-Bored Door
A dummy doorknob is one that does not turn, latch or lock. They are typically used on closet doors, bi-fold doors and...
Door Knob Assembly
Door knobs have curves that make assembly simple. Assemble a door knob with tips from a professional handyman in this free home...