Chiseling a recess -- called a mortise -- for a door lock plate is one of those jobs that’s very simple in theory but also very easy to mess up. If things don’t go well for you the first time, your lock will probably work fine after a few adjustments, but you’ll likely have to view the evidence of sloppy work for the life of the door. So, take the time to mark and cut carefully. Whether you’re installing a lock plate, also called a strike plate, for a deadbolt lock or a standard lockset, you first must install the lock or lockset onto the door, following the manufacturer’s instructions.
Things You'll Need
- Combination square
- Drill and bits
- Utility knife
- 1-inch wood chisel
Close the door, and look for where the lock bolt or latch bolt contacts the doorjamb. Mark the precise center (top to bottom) of the bolt onto the inside edge of the jamb using a pencil. Use a combination square to transfer this center mark across the face of the jamb -- that is, onto the flat strip between the inside edge of the jamb and the door stop.
Measure and mark a line along the center (side to side) of the jamb strip, intersecting the line made in the preceding step. At the line intersection, use a spade bit to drill a hole for the bolt as directed by the lock manufacturer. For flat-sided deadbolts, you typically drill two overlapping 7/8-inch holes centered about 5/16 inch above and below the horizontal center line.
Position the strike plate on the jamb so it is centered on both lines. Score around the plate with a sharp utility knife. Using a sharp 1-inch-wide chisel, cut a series of parallel lines into the jamb about 1/4 inch apart, staying within the scored lines and holding the chisel perpendicular to the wood.
Remove the waste wood with the chisel -- bevel side down -- held nearly parallel to the jamb. Clean out the mortise until its bottom is smooth and flat and at a depth exactly equal to the thickness of the strike plate. Test-fit the plate as you work to check the mortise depth.
Drill pilot holes for the strike plate, and fasten it to the jamb with the screws provided.
Tips & Warnings
- Here’s an easy way to mark the side-to-side position of a strike plate for a standard lockset: Draw along the vertical edge of the latch bolt (adjacent to the flat side of the bolt) with a pencil. Turn the knob, and hold it to keep the bolt retracted. Close the door tightly, and let go of the knob. The bolt will make a pencil mark on the doorjamb. Align the edge of the strike plate’s hole just to the door-side of the mark, and proceed with scoring around the strike plate.
How to Mortise a Door Hinge
A mortise is the carved-out area on a door where the hinge leaf is placed to lie flush with the surface of...
How to Use a Wood Chisel for a Door Hinge
Proper installation of a door hinge requires a recessed area, known as a mortise, to hold the hinge flush with the surface...
How to Recess a Door Strike Plate
A strike plate is a piece of hardware that works with a lock to keep a door secure. The strike is installed...
How to Install a Door Strike Plate
To install a door strike plate, you must first mark the location of the plate on the door jamb. Next, a hole...
How to Adjust a Strike Plate
The strike plate is the piece of door hardware that attaches to the door jamb and receives the latch. Latches that don't...
How to Install a Cabinet Magnetic Latch
A magnetic cabinet latch is simple to install with common home-repair tools. Magnetic latch kits typically include two working parts, plus mounting...
How to Fix a Strike Plate
A strike plate -- the metal plate affixed to a doorframe with an opening for a door latch or deadbolt -- that...
How to Hinge a Door Jamb
Your door swings on a pair of hinges installed on the side of the door and attached to the door jamb. When...
How to Mortise a Door Jamb
Mortising a door and door jamb for the hinges and strike plate often comes along with the job of replacing an old...