The heating element, thermostat and other heating-related components can be found inside the back of most dryer models. For this reason it is necessary to know how to remove the back of a dryer. The back panel is removed the same way on most common dryer models.
Things You'll Need
- Phillips-head screwdriver
- Nut driver
- Flathead screwdriver
Unplug the dryer power cord from the dryer wall outlet. Pull the dryer away from the wall so that you have room to work behind the dryer.
Disconnect the vent duct from the exhaust on the back of the dryer. Use a screwdriver to loosen the clamp securing the vent duct to the exhaust port. Pull the vent duct off of the exhaust port and position the duct out of your way.
Locate the electrical service panel that is beside the electrical cord where it enters the dryer. Remove the screws that secure the access panel to the back of the dryer.
Loosen the terminal block screws that secure the three or four wires of the power cord with a screwdriver. Loosen the clamp on the outside back of the dryer that secures the power cord to the dryer with a screwdriver. Pull the power cord out of the dryer back panel.
Use a nut driver or screwdriver to remove the screws that secure the back of the dryer to the dryer cabinet. If necessary, insert a flathead screwdriver between the back panel and side of the dryer cabinet to separate the back panel. The back panel can become sealed to the dryer due to heat, humidity and lint.
Tips & Warnings
- It is a good time to clean the lint from the dryer exhaust port while you have the lint duct removed.
- The spec sheet and wiring diagrams for the dryer may be attached to the inside back panel. Be sure not to lose these while working on your dryer.
- Always disconnect appliances from their power source before attempting repairs.
How to Remove the Back of an LG Tromm Dryer
The LG Tromm is a front-loading dryer with a control panel located at the top of the unit like a top-loading dryer....
How to Open a Kenmore Dryer Panel
No matter what you need to replace inside your Kenmore dryer—the belt, the motor, the idler, the drum supports or almost anything...
How to Remove the Back Panel on a Whirlpool Dryer
Most parts on a Whirlpool dryer are accessed through the top and front panels of the dryer. However, when the rear drum...
How to Remove Dryer Vent Lint
Removing dryer lint is an important step in maintaining your dryer and preventing a potentially dangerous fire. Each year, approximately 25,000 fires...
How to Remove the Back of a Kenmore Series 90 Dryer
The Kenmore Series 90 is an electric clothes dryer manufactured by Whirlpool and sold in Sears retail stores. The back panel of...
How to Open a GE Dryer
Testing and replacing the dryer heater coil, the dryer belt and the idler pulley or tensioning arm requires the opening of the...
How to Take the Back Off a GE Dryer
If you need to do internal work on your GE dryer, it will be necessary to remove the back of the appliance...