How to Use Craftsman Radial Arm Saws
Radial arm saws are designed for crosscutting wood--cutting wood against the grain. They can be used for ripping---cutting with the grain, but a regular table saw is better for that. Try it, though. Attachments are available for Sears' Craftsman Radial Arm Saws to convert them into a sander and a router. The Craftsman Radial Arm Saw uses a wooden table rather than a metal one. The fence is also wood, so you may need to replace it from time to time. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Test making a cross cut. Hold the board firmly against the fence. Support the board fully and make sure it lies flat on the table. Pull the saw towards you. Keep your hands away from the blade. Make the cut so the kerf is on the scrap side.
-
2
Test making a dado or rabbet. Raise the blade to the height you'd like and, again, check that the board is flat. Cut on each side of the notch, and make cuts in the interior.
-
-
3
Try a rip cut or beveled rip cut. Rotate the saw so the blade is parallel to the fence and board. Angle the blade to the desired angle. Hold the board very firmly. Kickback is a problem with this kind of cut. Feed the board into the blade and pull the board through.
-
1
