How to Make a Vaporizer Bulb
Rather than smoking your herbs, vaporize them to save yourself from the harmful health effects of smoking. Vaporizing heats up herbs to temperatures at which the herb's essential oils, which contain all of the active ingredients, are evaporated and released as vapor instead of combusted to produce smoke. Vaporization provides the same benefit as smoking does by releasing the active ingredients. Most commercially available vaporizers are expensive, but there is no need to purchase one when you can make one with everyday household products.
Things You'll Need
- Transparent 100-watt light bulb
- Serrated knife
- Duct tape
- Scissors
- Pliers
- 2 drinking straws
- Cap of a 2-liter soda bottle
Instructions
-
-
1
Slice off the bottom-most part of the metal component at the bottom of the light bulb with a sharp serrated knife. Sand off any resulting jagged edges.
-
2
Empty the light bulb completely of its contents using a pair of pliers.
-
-
3
Sanitize the light bulb by soaking it in a mixture of isopropyl alcohol 90% or higher and epsom salt for ten minutes.
-
4
Ensure that the two-liter soda bottle cap fits on the light bulb. Larger bottle caps may be fastened on with duct tape, but smaller bottle caps will not fit.
-
5
Poke two straw-sized holes in your bottle cap, about half an inch from each other.
-
6
Insert the drinking straws into the holes on the bottle cap and ensure that they connect the inside of the light bulb to the outside by trimming them to size with scissors. The drinking straws should be inserted at an angle perpendicular to the bottle cap.
-
7
Insert a couple pinches of ground-up herb into the light bulb from the open hole and screw on the bottle cap. Ensure that the bottle cap is secured on by using tape if necessary--the connection between the cap and the light bulb should be airtight, allowing airflow via the drinking straws only.
-
8
Turn the light bulb upside-down so that the bottle cap is on top and the herb on the bottom.
-
9
Vaporize your herb by heating the bottom of the light bulb with a lighter or candle flame. Move the flame in small circles around the bottom of the light bulb where the herb is to ensure even heating and maximize vapor yield. Inhale through one of the drinking straws when you begin to see a thin white vapor. Continue vaporizing until your herb becomes dark brown in color, which indicates that it is spent.
-
1
Tips & Warnings
The optimum vaporization temperature varies greatly with each herb. The right temperature for one herb may be too hot or too cold for another.
Grinding or breaking up your herb for maximum surface area will yield the most vapor.
Instead of using drinking straws, you may opt to use glass tubes.
Less herb is needed to achieve the same effect when vaporizing as compared to smoking.
Shake your herb around inside the light bulb to expose as much of it as possible to the heated glass and thus maximize vapor yield.
It is difficult to control temperature with a homemade vaporizer because the source of heat comes from a lighter or candle flame.
Do not overheat the light bulb or you can scorch the herb, thereby producing smoke and defeating the purpose of a vaporizer.
Do not use this device to vaporize marijuana or other illicit substances.
You may smoke the vaporized herb, but it will taste much worse, and be far harsher and less potent than fresh herb.
