Pressure treated lumber for outdoor construction is what most of us recognize as a piece of treated wood. The procedure infuses a compound into the wood fibers to slow decay and make our decks last longer. You can also treat wood with Borax though, a less commonly known way to cure wood with high water content, inhibit fire, and keep wood rotting insects away. Borax is a water soluble mineral that you can treat a number of products, including for use in the building industries.
Things You'll Need
- Freshly cut wood
- Water (2.5+ gallons)
- Borax (10+ ounces)
- Sprayer (pump type)
- Barrier protection (tarp/cloth)
Lay a protective barrier around the wood parts to be treated. The Borax solution can leach out onto the ground and can poison some types of grasses. Prevent Borax overdose to plants and animals by preparing a quality work area with the protection of an edge guard or with towels to catch any run-off of Borax solution.
Arrange the raw wood so that each side can be treated with the Borax solution. Check that you are able to flip the pieces on edge and over onto the other side to get an even coverage of Borax onto the wood boards. Take the pump sprayer and the Borax to a water supply and mix up a batch of Borax wood treatment.
Dissolve 10 oz. of Borax (20 Mule Team variety) into about 6 oz. of warm water. Agitate the solution until the Borax is dissolved. Pour this mixture into 1 gallon of plain tap water and mix so that it too is blended well. Now pour the treated gallon of water into the hand pump sprayer and tighten the cap of the sprayer. Pump it up to pressurize the inside.
Spray the solution evenly onto each side of the raw wood boards. A Borax component within the wood means this wood will be effective at repelling pest animals, inhibiting fire and curing faster by being treated with a simple Borax and water solution. Spray one side and then turn on edge and spray the edge, and turn and spray the back, and turn and spray the edge. That covers the entire board. Continue to spray boards until the solution is used. A gallon of solution will treat about fifty 2"X4"X8' studs.
Cure the wood as you would normally. It can be kiln or air dried until the moisture content reaches. Determine the correct moisture content for your area and dry the wood until it has the recommended amount of water in the fiber. Install the wood as you would any other type of treated wood.
Borax Termite Treatment
Borax is a mineral compound, also called sodium tetraborate or trisodium tetraborate, derived from the element boron. Borax has many uses, including...
Borax & Wood Floors
Borax and boric acid mixtures have well documented positive effects in the treatment and prevention of wood floor rot and infestation. Many...
How to Treat Lumber to Prevent Termites
Termites can wreak havoc on the foundation and framework of your home. Simple soil treatments can be effective for a limited amount...
How to Use Diesel and Borax to Preserve Wood
Wood is a renewable resource that, when treated properly, will last a lifetime with minimal decomposition and little need for replacement. Wood...
How to Treat Treated Lumber
Lumber is often treated against insects and the damage associated with long exposure to moisture. The wood is placed it vats of...
How to Apply Antifreeze to Dry Rot
Antifreeze, boric powder and boric acid can be effectively used to eradicate and prevent rot in wood. Boric acid and glycol are...
Propylene Glycol for Treatment of Mold & Termites
Termites and mold are two of the most destructive threats to wood. Chemicals, treatments and insecticides that are used to protect lumber...
Green Deck Cleaning
Every year tons of toxins are absorbed into the ground as a result of outdoor cleaning, such as deck, car and pet...
Home Remedy to Kill Dry Rot
Dry rot is caused by wood-destroying fungus that springs up when water penetrates wood, allowing the fungus and various bacteria and insects...