The gate for a picket fence is not usually meant to provide much of a barrier, but to offer more of an aesthetic appeal to the fence line. It has to be sturdy enough to support its own weight, and the picket design should match the rest of the fence. Other than some decorative hinges or a latch, the gate is little more than a movable section of fence.
Things You'll Need
- 13 1/4-by-4-by-40-inch pickets
- Bevel square
- 2 1-by-6-by-48-inch pine boards
- Framing square
- Drill with Phillips No. 2 screw tip
- 3/4-inch wood screws
- 2 Hinges with screws
- Latch with screws
Place two of the pickets together, back to back. Use the bevel square to mark a 45-degree angle across the end of the face. Mark another 45-degree line at the other end, so that the short side of both lines are on the same side of the picket. This is referred to as "short point to short point." Cut both along these marks. Set the pickets aside for now.
Place the two pieces of 1-by-6 on a flat surface. Place two pickets on top of these boards, one picket at each of the boards, and flush with those ends. One of the boards should be moved until it is 6 inches from the top of the pickets, and the other placed 6 inches from the bottom. Use the framing square to make small adjustments, and attach the pickets to the 1-by-6-inch boards using 2 3/4-inch wood screws at each board. Make sure that this frame fits your fence opening, and make adjustments to it before going any farther in the construction.
Turn the gate frame so that the two pickets are face down. Place two more pickets at the edges of the material, as before. These will line up exactly with the ones already mounted on the other side of the gate. Space the remaining pickets out evenly across the gate, mounting them to the cross members with one screw per picket per board.
Stand the gate upright so that the bottom of the pickets are all touching the ground. Brace the gate in this position to help you align it for the final braces. Place the two cut pickets on the 1-by material and roll the top piece over. Place the two pieces in the center of the gate so that the form a peak at the edge of the upper 1-by-6-inch board, and reach toward opposite ends of the lower one. Use the framing square a final time to align the gate, and attach the braces with two screws per joint.
Install the hinges so that the gate will be lifted 2 inches off the ground. For the most dependable results, use butterfly hinges with long wings on the gate side. This helps distribute the stress of the weight across a wider area, and offers a stronger hold with less stripping. Install your latch according to the instruction that come with it. There are many types of latches, but most require between two and four screws in both the gate and fence post.
How to Build a Picket Fence
The kids can’t play outside unsupervised; the puppy’s off down the street again. It’s time for a fence. You want to complement...
How to Build Gates for Wood Fences
A swinging gate is a must-have for any fenced-in area. At least 1 gate is always necessary and sometimes 2 or 3...
How to Build a Picket Gate
You've just finished your new picket fence, and now all it needs is a gate. There isn't much to it. Just gather...
How to Install a Gate on a Wooden Picket Fence
Installing a wooden gate on a picket fence is a three-part process that you can complete in only an hour or two....
How to Build a Cedar Fence Gate
Building a fence gate is not a terribly complex project; however, you need to ensure that you have a few basics in...