How to Attach a Dryer Vent
Dryers, whether gas or electric models, should be vented outdoors to remove unwanted moisture from the home's interior. The exhaust venting needs to be as short as possible with little to no turns or angles in the piping. The turns and angles can collect moisture and debris from the exhausting dryer. These particles and moisture can collect over time and perhaps create mildew or mold. Check with the dryer's manufacturer's specifications as to the correct hose diameter and type for your particular model. Does this Spark an idea?
Things You'll Need
- Vacuum cleaner (optional)
- Flexible dryer hose
- 2 Large spring clamps
- Pocketknife
- Wire pliers
- Foil tape
Instructions
-
-
1
Pull the dryer out from the wall. Allow yourself enough room to comfortably work behind the unit and the adjacent wall. Remove the old dryer hose and the connections.
-
2
Vacuum the area behind the dryer. Run the suction hose up and into the dryer vent itself. Remove all signs of lint from the dryer's exhaust.
-
-
3
Slide the large spring clamp over the end of the flexible dryer hose. Insert the hose over the dryer vent tube. Grasp the two sides of the spring clamp. Move the clamp over the dryer connection. Release the clamp.
-
4
Run the hose to the wall vent. Roughly measure the length of the hose and cut the plastic covering with the pocketknife. Cut the spring wire with the wire pliers to the length of the needed hose.
-
5
Slide the clamp over the end of the hose and attach the hose to the outdoor vent by following the same procedure as in step three above.
-
6
Seal all pipe and hose joints with the foil tape. Make at least two rounds with the tape to ensure an air tight seal. Push the dryer back into position. Take care so as not to kink or coil the flexible hose. Leave plenty of room between the rear of the dryer and the wall for the hose.
-
1
Tips & Warnings
Consult local codes for specific energy saving vents that maybe required for your area or building covenants.
