How to Remove the Front Panel From My Maytag Clothes Dryer

Save

If you are having problems with your Maytag clothes dryer, the first thing you should do is to remove the front panel. From here, you can access the high limit thermostat, the operating thermostat, the heater, the thermal fuses and the door switch. There are two common types of Maytag clothes dryer front panels--the standard front panel and the newer L-shaped front panel.

Things You'll Need

  • Maytag clothes dryer
  • Phillips head screwdriver

Standard Panel

  • Unplug the Maytag clothes dryer from the power source. Remove the two screws on the front panel. You will find them approximately 4 inches from the bottom, under the beveled edge.

  • Pull the bottom of the front panel toward you until the clips on the top of the panel release.

  • Carefully disengage the wires from the door switch and set the door aside.

L-Shaped Panel

  • Unplug the Maytag clothes dryer from the power source. Remove the four screws. You will find one in the hinge on the upper right, one in the hinge on the lower right and one opposite each hinge.

  • Lift the door slightly and pull back. The door and the hinges will disengage. Put the door aside.

  • The front panel of the Maytag clothes dryer is shaped like a goal post. Grasp the skinny, upper sides and wiggle them back and forth to unclip the panel. Pull the skinny ends of the front panel toward you, lifting it off the bottom clips. Set the front panel aside.

References

Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!