Proper wheel alignment is critical to your vehicle. Poor alignment can cause premature tire wear, sloppy handling and even problems controlling the vehicle. By learning how to adjust the tie rod ends, you'll learn how to adjust the toe, or the way the leading edges of your tires lean in toward the engine or out away from the vehicle. In this example, the vehicle is a Chevrolet Silverado pickup truck, but the procedure will be the same for many other vehicles.
Things You'll Need
- Tape measure
- Open-end wrench set
- 3/8-inch ratchet and sockets
- Channel-lock pliers
Lie on the ground and have your assistant help you measure the distance between the vehicle's two front wheels, measuring from the leading edges of the tires. The leading edge is the tread side that points toward the front of the vehicle. The easiest way to do this is to have the same reference point on each tire, so pick a vertical groove and both of you use that for reference.
Measure the distance between the wheels from the trailing edges of the tires. The trailing edge is the tread side that points toward the rear of the car. The difference between these two measurements is the amount your toe is off. It is possible that one side is off more than the other, but adjusting them both at the same time should fix the problem.
Locate the tie rod ends under the vehicle. They're mounted to the steering knuckle, and are generally 6 inches long with a ball joint at one end. An adjustment sleeve joins the tie rod to the steering linkage.
On one side of the vehicle, loosen the nuts on the adjusting sleeve with the 3/8-inch ratchet and socket. Then turn the adjusting sleeve with your hands or a pair of channel-lock pliers. By turning the adjusting sleeves toward the back of the vehicle, it pulls the leading edge of the tire toward the engine. By turning it toward the front bumper, it pushes the leading edge away from the vehicle. Repeat this step on the other side of the vehicle.
Re-measure the distance between both the leading and trailing edges of the tires with the help of your assistant and the tape measure. If the measurement is within 1/8 inch, then you're within the acceptable range. If not, repeat the process.
Tighten down the nuts on the adjustment sleeves using the 3/8-inch ratchet.
- How Loose Should Tie Rod Ends Be?
How to Adjust Your Car's Wheel Alignment
When you're driving along a straight and level road, your car should track straight as well. If it doesn't, your car is...
How to Change Tie Rod Ends
Tie rod ends are a vital ink in the steering of your car. If you're experiencing "play" in your steering wheel, check...
How to Replace Jeep Tie Rod Ends
Replacing the tie rod ends on your Jeep vehicle is needed when they have worn enough that the toe angle of the...
How to Adjust Toe Alignment
Adjusting toe alignment relates to moving the tires either inward or outward. An alignment machine takes into account the amount of free...
How to Adjust Toe-in of Wheel Alignment
Adjust toe-in of wheel alignment using a tie rod, turning it enough to bring the wheels out enough to correct the toe;...
When to Replace Tie Rods
On rack and pinion steering, the inner tie rods extend from the steering rack and directly attach to the outer tie rods...