How to Use a Drywall Jack
Whether you rent or buy, having a drywall jack available when hanging sheetrock or drywall is a necessity. You can use this handy device to raise or lift wallboard for installation on either walls or ceilings. Most drywall jacks are small enough to fit in the trunk of a car when broken down yet can easily reach heights of more than 10 feet. Using a drywall jack makes it possible for a homeowner to tackle those larger wallboard projects on his own. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Have your wallboard already on site. Make sure the work area is free of any debris or materials that will hinder the safe operation of the lift.
-
2
Put the lift together (if not already assembled). Typically lift assembly will consist of piecing together the tripod base, winch assembly and cradle. Since lifts vary in assembly procedure, refer to the supplied manual for exact details.
-
-
3
Test all working components---such as the cradle pivot, winch wheel and brake, wheel locks and telescoping supports---to make sure it is working correctly. Do not use the lift until you have checked to be sure the device is properly assembled. Once checked over, move the lift into the desired position to load drywall.
-
4
Lock the wheels on the base so the lift cannot move. Adjust the cradle so that the metal hooks on the bottom are set to catch the wallboard. Load the drywall into the cradle by raising one end and setting into place and repeating for the other end. Do this slowly to ensure that the drywall will not slip off the hooks. Make sure the finished side of the drywall is facing down (or out). Secure the drywall in the cradle with the lock (if equipped).
-
5
Adjust the loaded drywall and cradle so that it is set in a position which corresponds to how it will be installed. Unlock the wheels on the base, and roll the lift to the installation location. Most lifts are stable and should move easily to the desired location, but take your time when moving it to avoid damage.
-
6
Use the winch wheel to raise the drywall into the desired location for installation. It may be necessary to "nudge" the board and lift to get it placed exactly where you want it. Once you are happy with the location, use the wheel again to press the drywall against the framing. With the winch wheel brake set, the lift will hold the drywall in place. Secure the drywall with at least 8 to 10 drywall screws using a drill. Then lower the lift, and repeat for the next piece.
-
1
Tips & Warnings
Ask another adult to help load the drywall into the cradle. Prepare your tools and fasteners before you start installation. Most equipment rental stores have jacks available to rent.
Follow the manufacturer's operating instructions closely. Inspect all cables before using; replace if worn. Only lift one sheet of drywall at a time.
