You can construct a dam using sand bags and wood as a prevention against flooding, or to create a drained portion of an existing body of water. Unlike many other types of dams, the sand bag method is affordable and does not require rental of heavy machinery. For simple dams for small bodies of water (a creek or shallow pond) or in the path of a potential flood overwash, this method is quick and easy to learn but requires a considerable amount of physical exertion.
Things You'll Need
- Sand bags
- 6-inch hex bolts with nuts
- Crescent wrench
- 4-inch hex bolts with nuts (optional)
Decide where you are going to place your dam. Keep in mind that you should maintain as straight a line between the two end points of the dam (where the dam meets the shore) as possible. This will create an even pressure over the entire structure of the dam rather than focusing all of the water pressure on one point.
Place the bottom course of sand bags so that it is two sand bags wide, with the bottom seams of the bags touching. Think of the sand bags as being two pages in a book that is open and the spine is the short seam on the bottom of each bag. For this example, the dam described will fit a 4-foot deep, 8-foot wide creek. If the creek only runs when flooding, lay your sand bags directly on the dry creek bed. If the creek has water in it, place them in the water and guide them as they sink until they are lined up correctly.
Lay the next course on top of the first, with the sand bags laying across the two below as if laying a brick pattern. The sand bags will touch bottom to top as they are laid down.
Continue laying three more courses of double bags, alternating the direction the bags are going. The bottom 1/3 of any depth of water should contain this doubled layer and alternating course of sand bags.
Stack single sandbags one on top of another, aligned in the center of your double width bags until you have reached one foot past the height of the expected or existing water.
Measure and cut your 2x4s so that you can place one every three feet, at an angle, from the top of the sand bag wall extending down three feet into the ground at the base of the dam. Think of it as creating the frame for a lean-to; you want that angle but the boards placed so that they lay against the bags. Bury or drive the wood into the earth with a sledgehammer and shovel. If the ground is sandy, place a board beneath the end in the ground at an opposite angle to make an anchor kicker then bury both boards.
Lay boards across the frame every three feet, drill and attach them together with your hex bolts. Tighten well. Attach the ends of the board to trees or stakes made of 2x4s and driven well into the ground to provide further anchoring support for your dam.
- Practical Restoration Handbook; John Palmer, Inland Waterways Association; 2000
How to Make a Simple Dam
Dams, at their most powerful and useful, are extreme feats of engineering, requiring extensive work and research to ensure their safety. However,...
How to Make a Sandbag
Look no further than a sandbag for a change-of-pace workout. This deliberately awkward, old school training aid makes it nearly impossible to...
How to Make a Waterfall Dam
Waterfalls, with their pleasant sounds and appealing aesthetics, integrate well into backyard water features. Introducing a steep drop into a stream creates...
How to Build Dams With Rock & Soil
Building your own dam out of soil and rock can be a great way to increase the value of your property by...