How to Change a Honda Master Cylinder

The master cylinders on a Honda are generally good for the life of the vehicle. However, a seal failure inside the master cylinder can cause the cylinder to fail. This usually results in an initially firm brake pedal that slowly sinks to the floor. When this happens, you should replace the master cylinder so that you get consistent brake pressure pedal feel.

Difficulty: Challenging

Instructions

Things You'll Need:

• Socket wrench
• Socket set
• Tube nut wrench
• Catch pan
• New master cylinder
• Shop rags
• Masking tape
• Permanent marker

1. Place a catch pan under the vehicle and directly under the brake master cylinder.

2. Place shop rags directly under the brake master cylinder to control any leaks when you remove the cylinder.

3. Mark the location of each brake line to the master cylinder with masking tape and permanent marker.

4. Remove the brake line to master cylinder connection with a tube nut wrench. To do this, slide the tube nut wrench over the brake line and orient the wrench so that it fits over the end of the tube nut, then turn the nut counterclockwise.

5. Remove the brake master cylinder to brake booster mounting nuts and slide the master cylinder off the brake booster.

6. Install the new brake master cylinder. Installation is the reverse of removal.

Tips & Warnings

• For specific information about your particular Honda's brake master cylinder, consult the particular vehicle's manual (see Resources).

Resources

• Honda Service Manuals

Who Can Help Sponsored

• Need Cash For An Emergency? Auto Repair, Medical or Home Emergency—CashNetUSA.com is here to help you take control.