The Malibu is a mid-sized car sold by General Motors under the Chevrolet brand. The Malibu nameplate was once used in the 1970s on a full-sized rear-wheel-drive car. The name was resurrected in 1997. If you have a defective speaker in your Malibu, you will have to remove the door panel and the old speaker before replacement. The process is basically the same for 1997 to 2007 models.
Things You'll Need
- Flathead screwdriver
- Phillips screwdriver
- Wire cutters (optional)
Gather the tools needed to remove the door panel and access the front speaker. You will need a wire cutter for some older models of the Malibu. Keep one handy just in case. Unhook the negative battery cable for safety before beginning the procedure.
Pull open the interior door handle and use the flathead screwdriver to pry off the small trim panel behind the handle. Unhook the electrical connection from the door lock switch and the trim panel. Slide the trim panel around the interior door handle.
Pull the tabs to remove the panel inside of the door armrest cubby hole. Remove the two screws located behind the panel.
Pry off the two tabs in the lower-center part of the door panel. Remove the retainer screws from behind the tabs.
Depress the center of the fasteners around the perimeter of the door panel. Once the fasteners are pressed, they will easily pull out.
Carefully pull sections of the door panel from the door. Several clips mount the door panel to the door; be careful not to break them. Once the clips are detached, remove the door panel and disconnect the electrical connections for the power window/mirror switches.
Remove the screws mounting the front door speaker to the door. Carefully pull the old speaker from the door and disconnect the electrical module. The speaker wires of some older Malibu cars are directly soldered to the speaker connection. If this is the case, cut the wiring with the wire cutters to unhook the speaker.
Tips & Warnings
- Replacement of the door panel is the reverse of removal. Before reattaching the clips, make sure to connect the power window/mirror switches. Push the door panel in to lock the clips.
- If replacing the speaker with an aftermarket speaker, make sure to purchase a mounting bracket that will allow the speaker to fit.
- Photo Credit Ifcar/commons.wikimedia.org
How to Remove Car Door Panels
The process of removing car door panels is essentially the same for each make of car. You may need to remove these...
How to Replace Rear Deck Speakers
The speakers of the rear deck of your vehicle are the anchors of your sound system. They handle a wide variety of...
How to Remove a Chevy Truck Door Panel
Whether you need to replace a window motor, a speaker, install a window regulator, or you're just curious how it's connected, you...
How to Remove a Stereo From a Chevy Malibu
Every year, new aftermarket stereos come on the market to replace factory units in the Chevy Malibu. These stereos are often far...
How to Remove Rear Speakers in a 2007 Chevy Impala
The rear speakers in a 2007 Chevy Impala can be removed if you need to replace them. Because the factory speakers are...
How to Replace Chevy Silverado Speakers
Replacing the speakers in your Chevy Silverado is the easiest way to enjoy better sound without spending a fortune on high-end audio...
How to Install Speakers in a 2003 Chevy Silverado
Provides instructions to remove the door trim panels, modify the wiring if needed, and modify the bracket in the rear door, if...
How to the Replace Speakers on a 1998 Chevy
Chevrolet trucks of the 1998 model year are equipped with two pairs of speakers. One pair is mounted in the doors, while...
How to Repair a 2005 Chevrolet Malibu Power Window
Repairing the power window on your 2005 Chevrolet Malibu can refer to repairing the window itself or repairing the regulator that allows...
How Do I Remove the Back Seat on a 2005 Malibu Classic?
The 2005 Chevrolet Malibu Classic comes equipped with a back seat capable of folding down to make more room in the trunk...