How to trap moles and gophers using the Cinch Mole or Gopher Trap

Member

By moleguy
User-Submitted Article

Article Rating: (0 Ratings)

Cinch Mole and Gopher Trap

Trap moles and gophers using the Cinch Mole and Gopher Trap.

Difficulty: Easy

Instructions

Step 1

Begin by removing the mound of dirt from a fresh mound and dig down below the surface, usually about 6" to 8" and you will find 2 tunnels going in different directions. Remove enough dirt to allow for 2 traps to be placed in the tunnel system.
Step 2

Hold the trap so the set wires A and B are hanging loose. Pull the trigger wire back. The trap is now ready to set.
Step 3

Holding the trap firm with one hand, raise the active jaw wire and lower it to the opposite side of the trap base. Position the forward set wire across the active jaw wire.
Step 4

Position the rear set wire across set wire. Push the trigger wire forward making sure the set wire is positioned behind the tab. When you push the trigger wire you are in the guide area on the rear of the trap base.
The trap is now ready to be positioned into the mole run.
Step 5

Place the traps in opposite directions (2 traps are recommended for the best results). It is not necessary to cover the opening unless you are concerned with pets or other interference. When the mole or gopher returns to investigate the disturbed tunnel area, it will activate the trigger and the powerful springs steel jaws will close around the middle of its body causing instant results. Remove the trap, replace the direct and continue to observe the area for further activity.

Comments