How to Grout Tile on a Bathroom Floor
There are very few home improvements that are as beautiful as custom tile floors. Tile can add character to any room in your home, especially the bathroom. Laying tile is not difficult and can be done by any homeowner who is willing to invest the effort to beautify his home. After laying the tile, make sure that you apply grout to strengthen the tile joints. Select a color that will add contrast and accent to your bathroom floor. Does this Spark an idea?
Instructions
-
Grouting a Tile Floor
-
1
Mix the grout according to the manufacturer's directions. The grout should be a little thinner than the consistency of mayonnaise.
-
2
Use a trowel to scoop a generous amount of grout onto the tile floor. Hold a rubber grout float at a 45-degree angle to the floor, and spread the grout along the joints between tiles.
-
-
3
Press the grout into the joints by forcing the grout in with the float. Move the float in line with the tile joints, then move the float diagonally across the joints to fully fill the gaps.
-
4
Scrape off the excess grout from the face of the tile using the grout float. Avoid scraping grout from the joints. Allow the grout to set for 30 minutes.
-
5
Use a damp sponge to continue to clean the tile faces. Rinse the sponge often to keep it clean. Repeat the tile cleaning as needed until the floor is clean.
-
1
Tips & Warnings
Start at the perimeter of the room and gradually work your way into the center.
Make sure that the sponge you use to wipe the tiles is damp but not dripping wet. Excess water can get into the tile joints and dilute the grout, making it more likely to crack.
