How to Restore a Billiard Table

Save

To restore a billiard table that has worn down over time, you can easily order replacement rails, pockets and legs, as long as they fit the size and style of your table. You can also refinish the table, replace the rail cushions and re-cover the table with new billiard cloth yourself. The exact restoration process will depend on the type of table that you're restoring.

Things You'll Need

  • Wrench
  • Screwdriver
  • Sandpaper or sander
  • Wood stain
  • Veneer sheets (optional)
  • Putty knife
  • Vulcanized rubber cushions
  • Utility knife
  • Billiard cloth
  • Disassemble the table. Remove the rails, which are often bolted on from the underside. Unbolt and remove the pockets. Pull out the staples (if any) for the cloth and peel it off the slate bed, then remove the screws attaching the slate. Disconnect the legs by removing their bolts or screws.

  • Inspect the condition of the table's base and apron and decide if and how you want to refinish it. There are multiple ways you can do this; sand the surface and apply a fresh coat of stain or varnish, or glue veneer sheets to the sides for a new look.

  • Refinish or replace the legs. Apply the same style of refinishing that you used for the base and apron. If you want or need to replace the legs, replace all four together and get a set that can properly support the size and weight of your table.

  • Replace or restore the rails. Peel the billiard cloth off and carefully pry off the cushions with a putty knife. Clean off the dried glue with adhesive remover, use contact cement to glue the new cushions to the rails and trim the rubber along the edges with a utility knife.

  • Replace the slate bed if it is cracked or damaged. Purchase a slate bed that's the correct size for your table. A 9-foot table requires a bed that's 100 by 50 yards; most home tables are smaller. Screw the bed to the table after reattaching the legs.

  • Cover the table with new billiard cloth; 21 to 24 oz. is usually needed. Cut strips of cloth to glue to the rubber cushions on the rails. Apply an adhesive spray to the slate, stretch the fabric across the table as tight as it can go and staple it to the table near the edge. Trim the cloth where the pocket holes are and staple the cloth to the inside of the holes.

  • Reconnect the rails, pockets and any other pieces to reassemble the table.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Restore a Wood Table

    Wood furnishings add warmth and durability to the home. Wood is porous and can be damaged by water and nicks and scrapes....

  • How to Identify Antique Pool Tables

    Antique pool tables are a treasure indeed. Quality pool tables--antique or not--have six legs and three pieces of heavy slate in the...

  • How to Recover a Slate Pool Table

    This guide could help you with creative ways to recover your home pool table in no time and make it look stellar...

  • How to Refinish a Pool Table

    Torn fabric on your pool table is a disaster. Patching up the torn cloth won't help at all, because it will leave...

  • How to Restore Mahogany Furniture

    Older wooden furniture with a damaged finish doesn't necessarily have to be stripped and refinished. In fact, when dealing with furniture that...

  • How to Restore Cue Sticks

    Line up and make the perfect ricochet pool shot, and you could have the whole pool hall cheering your name. Pool is...

Related Searches

Read Article

19 Home Decor DIYs That Only Look Expensive

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!