How to Make an Earthquake Model for Kids

Save

Earthquake models vary from complex to easy to make. If you're working with kids, you can make a fun and easy earthquake model out of gelatin. Best of all, the kids will have fun eating it afterward.

How to Make an Earthquake Model for Kids
(Ignacio Lopez/Demand Media)

Things You'll Need

  • Baking pan, 8 x 8 inches
  • Measuring cup
  • 2 1/2 cups water
  • Pot
  • Stove
  • 12 oz. powdered gelatin (two standard-size boxes)
  • Spoon
  • Plastic wrap
  • Scissors
  • Knife
Step 1

Pour the water into the pot, and heat it on the stove until it comes to a rolling boil.

Ignacio Lopez/Demand Media
Step 2

Pour the boiling water into the baking pan, and stir in the gelatin powder.

Ignacio Lopez/Demand Media
Step 3

Put the pan into the refrigerator for several hours, until gelatin is firm.

Ignacio Lopez/Demand Media
Step 4

Cut a piece of plastic wrap in half and lay the two halves, touching each other, on a counter.

Ignacio Lopez/Demand Media
Step 5

Remove the pan from the refrigerator. Warm the bottom of the pan by holding it aloft over low heat until the gelatin can be removed.

Ignacio Lopez/Demand Media
Step 6

Slide the gelatin out of the pan and onto the plastic wrap, putting about half of the gelatin on each side of the wrap.

Ignacio Lopez/Demand Media
Step 7

Make a cut in the gelatin that runs along the same area as the cut in the plastic wrap.

Ignacio Lopez/Demand Media
Step 8

Slide the two chunks of jello past each other. The chunks of jello act like Earth's plates. When they slide past each other, you will see an earthquake form along the "fault."

Ignacio Lopez/Demand Media

Tips & Warnings

  • Sanitize the counter before making the model. That way, even if the gelatin slides off the plastic wrap, it will still be safe to eat.
  • Be careful when using boiling water around children.

References

Promoted By Zergnet

Comments

Related Searches

Check It Out

Can You Take Advantage Of Student Loan Forgiveness?

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!