How to Replace a Broken Garage Door Spring

If you have a broken garage door extension spring, here are steps to replace it. The extension or recoil springs allows the heavy garage door to be open by hand or assists the garage door opener to retract the door.

Difficulty: Moderate

Instructions

Things You'll Need:

• Replacement Extension Spring(s)
• 2 x 4s, ladder, or any props to support a garage door.

1. 
   Old spring - note broken end

   Keep the old spring handy. This will help you find the correct replacement.

2. 
   Old and new spring with same color code

   Note the painted color on the end of the old spring. It may be difficult to see the paint if the spring is very old and rusty but even a trace of paint will have color. The color determines the right spring and corresponds to a garage door weight and size. It is also possible to determine the replacement spring by the size of the old one.

3. 
   Color on old spring

   In this example, a plain blue is used. You can find the garage door spring in a hardware store such as Lowes and Home Depot. They can also be purchased through the Internet.

4. The spring ends can have double loops or single loops. Double loops will be a little tougher to attach.

5. 
   Emergency release handle

   If you have a garage door opener, pull the emergency release so you can manually open the garage door.

6. 
   Propping garage door

   Prop the garage door all the way up with 2 x 4s or even a ladder. Place an obstacle like a wheel barrel or large storage containers where the door meets the ground to protect yourself in case the 2 x 4s or other props collapse. If the garage door is very heavy or is bigger than a one car garage door, have someone to assist you prop the door.

7. 
   Pulley wheel clip attached to spring loop

   Attach the end of the spring to the pulley clip or hook end that pulls the door as shown. It can be difficult with a double loop. Use a screwdriver to make a gap on the loop to get it in the pulley clip.

8. 
   Completed project with door down showing location pulley wheels, cable, and spring

   Make sure the metal cable or line is in all the pulley wheels before you attach the other end of the extension spring. While you are putting the spring back to the hook, make sure the metal line or cable, pulley wheels, and springs are lined up properly and not twisted or off in any way.

9. 
   Spring loop attached to far hook. Note a cable was used to assist in stretching spring a few inches

   Attach the other end of the spring to the far hook that will put the spring, pulleys, and cable in place. This can be difficult if you need to stretch the tight spring an inch or two. Move the door up to get the spring closer. If the door can’t move anymore, grab a chain or metal line and have someone pull on the spring so you can hook the spring loop.

10. Remove the props and manually bring the door down. Put the emergency release back to normal. You may have to move the traveler assembly and bang the release bar back in the traveler.

11. Double check if the emergency release is back because it could be difficult to put back if you test the garage door opener and the traveller cable hook separates from the traveler.

12. Test the operation of the garage door and adjust to make sure the door touches the ground all the way or not hit the ground too hard.

Resources

• Lowes
• Home Depot
• Source for extension spring