How to Backflush a Pool Filter

Save

Swimming pool filters remove dirt and debris from the water. The most common type of filter uses #20 silica sand as the filtering media. Grains of sand have jagged edges that snag particles as they flow by. Spaces between each grain begin to fill up with trapped debris, reducing the available paths for water to flow. This reduction in paths produces an increase in pressure inside the canister holding the sand. When the pressure gauge on the canister increases by 8-10 lbs. of pressure over the beginning pressure, it is time to backflush the filter and remove the debris.

Things You'll Need

  • 50' backflush hose
  • Hose clamp
  • Turn off the pump.

  • Depress the handle of your multi-port valve by applying firm pressure until it turns freely without scraping. Turn the handle until it is in the backflush or backwash position, and release the tension on the handle.

  • Check your backflush hose connection to make sure that the hose clamp is secure. A loose clamp will not stand the force of the wastewater exiting the pool and can cause flooding if it pops off. Since your backflush hose always remains connected to the waste port of your filter system, it is easy to overlook. Periodically, make sure that the far end of the backflush hose, which is normally about 50 feet from the pool, is still directing the waste water where you want it to go on your property.

  • Turn on the pump, which will reverse the flow of water inside the canister and clean the sand of trapped debris. Run the pump until the water flowing through the canister's sight glass changes from dirty to clear.

  • Turn the pump off to stop the rapid loss of water out of the pool.

  • Depress the handle on the pump and turn it to the rinse position.

  • Turn on the pump for 20-30 seconds, then turn it off. This action settles the sand and makes sure that none of it is in the wrong compartment inside the multi-port valve. Without this step, sand may end up on the bottom of the pool.

  • Turn the pump off.

  • Add water back into the pool, making sure to test and treat it chemically. The water level should be at the middle of the skimmer opening.

  • Turn the pump's multi-port valve to the filter position and turn the pump on.

  • Make note of the starting pressure on your pressure gauge and treat it as your new benchmark for backflushing. Backflush only when the pressure rises 8-10 lbs. higher than where it is now.

Tips & Warnings

  • Only use #20 silica sand in the pump. Play sand or other types of sand have smaller grain sizes and will be pulled through the slotted openings of the laterals or fingers in the base of the canister, and will end up in the pool.
  • Pay close attention to your pressure gauge and backflush when necessary to relieve pressure. The pressure can cause an explosion and do severe harm if not attended to. Do not backflush unnecessarily. Allow the dirt and debris to plug up some pathways in order to filter fine materials.

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!