How to Make Sodium Chlorite

Sodium chlorite is used commercially to bleach fabrics and paper and to purify and disinfect municipal water. Homeowners use sodium chlorite as an anti-fouling agent for water and a precursor for other flammable or explosive chemicals. There are many different ways to make sodium chlorite. Commercially, chlorine dioxide is added to sodium hydroxide and hydrogen peroxide. For the home chemist, table salt is added to water for a saturated solution, then electricity is applied to bond the O2 from the water to the salt. Some people like to add battery acid or another caustic agent to speed up the process, however, this can result in an unstable, explosive solution.

Difficulty: Moderately Challenging

Instructions

Things You'll Need:

• Safety goggles
• Gloves
• Glass beaker or heatproof wide-mouthed jar
• 1/2 cup of table salt
• 3 quarts of water
• Heat source
• 9-volt battery or solar panel with voltage greater than 1.5 volts
• 2 pieces of electrical wire approximately 12 inches long with attached alligator clips at each end
• 2 #2 pencils with erasers and metal holders removed
• Pencil sharpener
• Piece of cardboard that fits over the mouth of the jar
• Electrical tape
• Sharp knife
• Coffee filter
• Funnel
• Heatproof plastic container
• Wire rack

Making Sodium Chlorite

1. Pour 3 quarts of water into a wide-mouthed, heatproof glass jar or glass beaker and heat to just under boiling.

2. Add the 1/2 cup of salt to the water; continue heating the mixture until the salt is completely dissolved. Remove from heat when the salt is dissolved.

3. Sharpen both ends of the pencils until you have at least 1 inch of exposed lead on both ends.

4. Attach the wires to one end of each pencil with the alligator clip. Make sure the clip is only gripping lead.

5. Tape the cardboard to the mouth of the glass jar or beaker.

6. Punch holes in the cardboard an inch in from the sides of the jar. Insert the ends of the pencils without the alligator clips into the holes and push into the jar until the exposed lead is submerged in the salt/water mixture.

7. Attach one alligator clip to the negative terminal and the other alligator clip to the positive terminal of the battery or the solar panel. This provides the electrolysis which turns the NaCl to NaclO2. Wait at least 16 hours before disconnecting the electrolysis.

8. Disconnect the alligator clips from both the battery or solar panel and the pencils. Remove the pencils and cardboard from the glass jars.

9. Line the funnel with a coffee filter and place in the plastic container. Pour the salt/water mix through the coffer filter-lined funnel. The sodium chlorite will be caught by the coffee filter.

10. Remove the coffee filter from the funnel and gently place on a wire drying rack with the side that had the salt/water mix poured on it up.

11. As the coffee filter drys, sodium chlorite crystals form. You can gently scrape the crystals from the coffee filter into a storage container.

Tips & Warnings

• You can speed up the electrolysis process by keeping the salt/water mix warm.

References

• Electrolysis
• Sodium Chlorite Properties

Who Can Help Sponsored

• Earn your degree from industry experts at University of Phoenix. Take the next step in your career.

[gorbag]

on 11/5/2009 How interesting famoussnatcher! I have been searching all over the web for the same reason. If you find the answer, please leave it here, and so will I.

[famoussnatcher]

on 10/14/2009 Looking elsewhere on the web, it seems you're actualy making Sodium Chlorate, not Sodium Chlorite. Could you please confirm your recipe and point out the differences in the process of making Sodium Chlorite vs Sodium Chlorate?