How to Use Neato CD Label Applicator
The Neato CD Label Applicator is an easy way to label a CD. Before applying the adhesive label to a CD, make sure there is no dust or debris on the surface of the CD, as this could prevent the adhesive label from forming a good bond. When applying the CD label, keep in mind that the label needs to lay as flat as possible. Wrinkles or tears in the label may cause skipping or playback errors in certain CD players.
Other People Are Reading
Instructions
-
-
1
Place the Neato CD Label Applicator on a flat surface. The base should rest flat, with the post of the plunger facing upward.
-
2
Remove the printed adhesive CD label from its backing. To do this, lay the paper on a flat surface, printed side down. Hold down an edge of the printed CD label with either your finger or a pointed instrument while you simultaneously lift away the backing. This procedure will help minimize tearing or curling.
-
-
3
Place the printed CD label on the Neato CD Label Applicator, sticky side up. Make sure it is laying flat on the base.
-
4
Orient the hole in the CD over the post and lower the CD onto the base, data side up (the reflective side of the CD).
-
5
Press down on the center of the CD. Avoid touching the reflective area of the CD. Instead, try to keep your fingers on the plastic center ring.
-
6
Remove the CD and push out any air bubbles under the label by running your fingers around the CD in a circular motion.
-
1
